Preview only show first 10 pages with watermark. For full document please download

Fcubed Installation Manual

   EMBED

Share

Transcript

(9) (10) PRESSURE EMMITTER INSTALLATION CONNECTIONS waste and distilled water pressure reducing emmiterreducing must beemitter installed. if using a pressure fed system must be installed (1) Connect pipe to distilled water oultet. (2) Connect pipe to waste water outlet. source pump 13mm adapter (2) micro adapter (1) feed pipe tap top of still pressure reducing emitter MUST be installed in a pressure system. (11) (12) WATER gravity water set up. 20 L 40 L 60 L FUNCTIONING PANEL set up 40 L Carocell http://www.fcubed.com.au/ F Cubed Australia Pty Ltd 23 Fillo Drive Somerton Vic 3062 Australia. ph. +61 3 8339 0006 fax. +61 3 8339 0083 Instructions (2) (5) MOUNTS (6) LEGS assemble long leg. assemble right mounts. ORIENTATION setting up direction. 5 500 mm L L maximum distance 500mm for gravity fed container south R 90° 90° R leg nylon steel wingnut 0° gradient. 2020mm R R equator (1) PARTS contents of pack. R x 1 larger leg x 8 screws L maximum distance 500mm for gravity fed R x 8 steel washers north x 1 smaller leg 90° x 8 nylon washers x 1 6L/H drip emitter x 4 black mounts ( 2 left, 2 right) R 90° x 1 spirit level (3) 0° gradient. 2020mm (4) MOUNTS assemble left mounts. (7) LEGS secure panel to ground assemble small leg. setup. if using a pressure fed system reducing emitter must be installed place level on top edge of front and rear legs. R L (8) FEED PIPE ASSEMBLY AND INSTALLATION SECURE R 0° gradient. source L 0° gradient. leg nylon steel L wingnut L 13mm adapter gently push and turn pipe through hole until it stops 0° gradient. L feed pipe micro adapter L tap L R top of still