Transcript
Shenzhen Wekomp Technology Co,Ltd
Dual SD Card Mobile DVR ¾ Model No.:WP-CW1000
z Features
New generation anti vibration mechanism and special connector for vibration resistance
Wide power input range: 8VDC~36VDC
GPS, 3G (EVDO/HSDPA), External WIFI (802.11b/g) optional
8 s delay after power off
Built-in G-force sensor
Support two 32 SD cards, maximum64 GB for each
Support SD card upgrade
GPS location tracking, speed detection and sync time
Built-in power supply for cameras
Water mark, special file system
H.264 video compression, dual stream
CE, FCC Certificate
z Selection Guide Product Name
G-sensor
GPS
3G
WIFI
WP-CW1001
√
×
×
×
WP-CW1002
√
√
×
×
WP-CW1003
√
√
√
×
WP-CW1004
√
√
×
√
WP-CW1005
√
√
√
√
1 z Specification Model
WP-CW-1000
Function Overview
Live view, recording, playback, GPS location tracking, Network
System
Video
OS
Embedded Linux
Control mode
IR remote control, network or control panel
Input
4 channel video inputs, 1.0Vp-p, 75 ohms, 4 Pin connector
Output
1 channel RCA output, 1 channel 4 Pin connector output, 1.0Vp-p, 75 ohms
Total Resource
D1@50fps
Video system
NTSC/PAL
1
1
Shenzhen Wekomp Technology Co,Ltd
Audio
Display
Input
Audio input x 4, 4 Pin connector
Output
1 channel 4 Pin connector output
Display split
1/4
OSD
GPS information, alarm, temperature, acceleration, voltage, device information, firmware version, MCU version, network status
Operation Interface
Semi-transparent GUI
Video/audio compression
H.264 Main Profile / ADPCM (8 kbps)
Image resolution
PAL: D1 (704×576), Half D1 (704×288), CIF (352×288) NTSC: D1 (704×480), Half D1 (704×240), CIF (352×240)
Video rate (kbps)
D1: 400Kbps~2048Kbps; HD1: 380Kbps~2048Kbps; CIF: 128Kbps~1536Kbps
Image quality
1~8 levels adjustable ( Level 1 is the best)
Recording mode
Always, alarm, schedule
File packing time
15, 30, 45, 60 minutes
Pre-recording
Maximum 60 seconds
Post-recording
Maximum 30 minutes
SD card mirror Recording
N/A
Overwrite
Support, first in first out
Anti-overwrite
Alarm video can be protected, different protection time can be set 1, 3, 5, 7, 15 days
Metadata
GPS, temperature, voltage, speed, acceleration, sensor status
Audio
ON/OFF, recorded simultaneously
Playback Channel
1/4 (1 channel by local playback, 4 channels by PC software)
Search mode
Date/time, channel, file type, event, driver ID etc
Backup mode
SD Card
Ethernet
N/A
3G
HSDPA/EVDO (optional)
WIFI
802.11b/g (optional)
GPS
GPS location tracking, speed detection and sync time
Storage
SD Card
2 SD cards, maximum 64GB for each
Alarm
Alarm in
GPIO alarm in x6, high level >4V, low level < 4V
Alarm out
GPIO alarm out x2, output high level 12V
HDD error
N/A
G-force sensor
Built-in G-force module, X Y Z sensitivity adjustable
Speed detection
Via GPS or pulse signal from vehicle
Video lost
Support
Motion detection
Support, sensitivity adjustable
Temperature
N/A
Recording
Playback & Backup
GPS/Network
1
2
Shenzhen Wekomp Technology Co,Ltd
Interface
Power
Panic button
External panic switch button
USB
N/A
RS232
RS232 ×1
RS485
RS485 ×2
Audio amplifier (speaker)
Audio amplifier ×2
Alarm
GPIO alarm in ×6, high level >4V, low level < 4V
Input
8~36V
Output
DC 12V@2A
Consumption
<15W (Without cameras)
Ignition
Support delay shut down, ignition on≥5V, ignition off≤4V
Protection after power lost
Mechanism
Dimension (L×W×H)
180.3×162×47.2mm
Weight
0.9 kg
Installation
Front installation, Side installation
Operating temperature Environment
Support, max. 8s
-40°C~+80°C (Under well-ventilated environment, please use built-in heater if the temperature is below 0°C)
Operating humidity
10%~90%, no condensation
Certificate
CE, FCC
z Dimension
z Mechanical A) Indicator light on Front Pannel
1
3
Shenzhen Wekomp Technology Co,Ltd
Name
Description
V-OUT
Analog Video Output
SD1/ SD2
LED
Recording SD card indicator light, light will be on when the SD card exists
REC
Light will be on when recording
GPS
Light will be on when the GPS module exists
POWER
Light will be on when the power supply can work normally
ALM
Light will be on when the machine is in abnormal situation
WIFI
Light will be on when the WIFI is ON
2G/3G
Light will be on when 3G communication module exists
IR
Infrared sensor receiving remote control signal
B) Rear View
1
4
Shenzhen Wekomp Technology Co,Ltd
Name
Description
3G
Supports GPRS/ EVDO/HSDPA Antenna
Wi-Fi
Wi-Fi Antenna
GPS
GPS Antenna
POWER
Power Input
CAM 1~4
Video/Audio Input
A/V OUT
Video/Audio Output
RS232 RS485 SENSORS SPEED
RS232/485 Serial port, Switch inputs, Bus speed pulse
Speaker
Audio Power amplifier output
Extension
Control panel interface
z Application
z Accessories
1
5
