Transcript
TEMP-SURE FRONT FLYER REV 1-2016_Layout 1 1/15/16 10:07 AM Page 1
FEATURING CMA TEMP-SURE BOOSTER HEATERS Features A Hot Water Booster Option for Peace of Mind
Booster Heater
Booster Heater Booster Heater
Model E-AH Also Available as E-Corner
Model EST Also Available as Straight or Corner
Is your Low Temp dishmachine lacking an adequate supply of hot water to assure proper sanitation is taking place in the dishroom? We have the answer “CMA TEMP-SURE”. Rather than replace your existing water heater with something larger and more expensive, add the “TEMP-SURE” booster heater to your machine. The “TEMP-SURE” is mounted to the side of dishmachine, not requiring any of your valuable kitchen space. The “TEMP-SURE” provides an additional 40 degrees of temperature rise to your incoming dishmachine water supply, which will help prevent your existing water supply source from being over burdened. Have “PEACE OF MIND” that proper dishware sanitation is taking place and preventing health risks. (Available on most CMA dishmachines).
DISHMACHINES 10108.40
Model B (Double) Also Available as Corner B
Hot Water Booster Heater
The “TEMP-SURE” can be built-in at the factory, or it can be purchased separately with a field kit for field installation.
*The “TEMP-SURE” requires a separate 208-230v 3 phase 40 amp power supply.
12700 KNOTT STREET GARDEN GROVE, CALIF. 92841 800-854-6417•714-898-8781•FAX 714-895-2141 www.cmadishmachines.com
C
UL R
LISTED
US
COMMERCIAL DISHWASHER 864T
CMA ® Registered Trademark
1-2016
Temp-Sure Sheet Back 1-2016_Temp-Sure Sheet Back 1/15/16 9:07 AM Page 1
CMA TEMP-SURETM Hot Water Assurance System For Dump And Fill Style Dishwashers
DISHMACHINES
WARNINGS: • Plumbing connections must be made by a qualified service company who will comply with all available Federal, State, and Local Health, Plumbing and Safety codes. • Water hardness above 3 grains per gallon should be treated by a water softener. Failure to provide soft water (3g or less) will void the machine warranty. 1/2" MALE PIPE THREADS HEATER ROCKER SWITCH
HEATER ROCKER SWITCH
OUTLET
8 3/4"
* CAUTION: WATER SOLENOID MUST BE PLUMBED AHEAD OF HEATER INLET. HEATER IS NOT A PRESSURE VESSEL.
*INLET
7" FRONT
BACK
3 PHASE WIRE SCHEMATIC ROCKER SWITCH
CHANGES FOR 1-PHASE (TIE STRAPS CHANGED AS SHOWN) ON HEATER
3
HIGH LIMIT SWITCH RED
2 8
RED BLUE
TOP
RED
THERMOSTAT TOP
L-2
L-1
T1
L-3
T-2 L-1
T-1
L-2
L-1
L-3
L-1
L -2
L-2
GROUND
T-3
T2
Power Supply: Hook Up Wire With Highest Voltage On L-2.
HEATER ROCKER SWITCH
5/16" MOUNTING HOLES (4)
25" OUTLET
24"
79/16"
*INLET LEFT SIDE 1/2" MALE PIPE THREADS
RIGHT SIDE
The CMA-Temp-Sure TM option assures a continuous supply of 140°F hot water resulting in excellent dishmachine performance. The heater is custom-designed for fill and dump CMA single tank dishwashers as a factory added option or an infield add-on. The heater will also fit most competitor’s single tank dishmachines. Advisory: CMA does NOT endorse “Tankless On-Demand” water heaters for use on CMA Dishmachine products. CMA DOES endorse, and highly recommends, the standard “tank” style water heaters, sized properly to handle each particular facility with their water heating requirements.
C
UL R
LISTED
US
COMMERCIAL DISHWASHER 864T
1/2" MALE PIPE THREADS
1" ELECTRICAL INLET
SPECIFICATIONS: MODEL: CMA TEMP-SURETM MIN. INCOMING WATER TEMP. RISE AVAILABLE HOT WATER HEATER TANK CAPACITY ELECTRICAL RATING
VOLTS 208 240 208 240
USA 100°F 40°F 90 GPH 2.6 GAL PHASE 1 1 3 3
METRIC (55°C) (22°C) (341LPH) (9.8L) AMPS 44 51 26 30
CMA ® Registered Trademark
CMA Dishmachines 12700 Knott Street, Garden Grove CA 92841• 800-854-6417 • 714-898-8781 • Fax: 714-895-2141 • www.cmadishmachines.com CMA reserves the right to modify specifications or discontinue models without prior notification.
PN: 10108.40
© 1-2016 CMA, Inc.
