Transcript
Integrated Fridge Freezer FF250IHE
Instruction Manual
Important: Please read these instructions thoroughly before using your appliance. Keep them in a safe place for future reference.
SAFETY INFORMATION x This integrated fridge freezer is intended for normal household use. x The appliance is designed for indoor use only. x Wait at least 2 hours before first powering up the appliance to allow the cooling system to settle after transportation. x Do not allow children to play with the appliance to avoid the risk of entrapment and suffocation. x Do not use mechanical, electrical or chemical methods to speed up the defrost process. x Do not store liquids in glass containers in the freezer as these may shatter. x Do not store flammable materials such as alcohol, gasoline, LP gas or glue, etc, in the freezer. x
This appliance contains the refrigerant isobutene (R600a) which is flammable. x If the refrigeration circuit should become damaged, avoid naked flames and sources of ignition. Thoroughly ventilate the room in which the appliance is situated. x If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or suitably qualified person, in order to avoid a hazard. x Any electrical work required to install the appliance should be carried out by a qualified person. x This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. x Do not position the appliance near a heat source or in direct sunlight. x Ensure that sufficient space is left around the appliance to provide adequate ventilation. x Do not use single/multiple adapters or extension cables. x This appliance is designed to be built-in.
1
x Warning! The light bulb supplied with this appliance is a “special use bulb” which is usable only with this appliance. It must not be used for domestic lighting. x Warning! Do not touch the light bulb, if it has been on for a long period, as it will be hot. x It is recommended that 2 people unpack and install the appliance. x The appliance must be installed in a kitchen cabinet which is strong enough to support the freezer when it is fully loaded. x Do not install the appliance in a moist or wet environment. x This appliance is suitable for use in an ambient temperature of 10 to 38°C. WARNING: This appliance must be earthed. x Any electrical work that is required to install the appliance must be carried out by a qualified electrician. x The fridge freezer should be powered from a 220-240V 50Hz supply. x It is recommended that the socket is still accessible after the appliance has been installed.
PRIOR TO INSTALLATION x Remove all packaging from inside the appliance. x Thoroughly clean the inside of the appliance. x Ensure that the size of the kitchen cabinet and ventilation areas are large enough.
INSTALLATION KIT
Guide x 4
Guide Cover x 4
Slider x 4
Slider Cover x 4
Short Screw x 27
Long Screw x 2
Rubber Seal x 1
Middle Bracket Cover x 2
2
REVERSING THE DOOR OPENING The appliance is delivered with the doors opening from the left hand side. To change the opening direction, please follow these instructions. Note: Ensure that the appliance is unplugged and empty before reversing the doors. 1. Unscrew the top hinge and then lift off the upper door and place it on a padded surface to avoid scratching it.
Note: It is recommended that an 8mm spanner is used to remove the screws that fix the top hinge and middle brackets.
2. Unscrew the middle hinge and bracket on the right hand side and then lift off the lower door and place it on a padded surface to avoid scratching. Unscrew the middle bracket from the left hand side of the cabinet.
3
3. Remove the bottom hinge pin from the right hand side and transfer it to the left.
4. Re-position the lower door onto the bottom hinge pin and locate the middle hinge pin into the top of the lower door. 5. Re-fit the middle hinge and bracket. Ensure that the door is aligned horizontally and vertically so that the seals are closed on all sides, before finally tightening the screws. Re-fit the middle bracket to the right hand side of the cabinet. 6. Remove the top hinge pin from the top hinge. Turn the hinge over and re-fit the hinge pin.
7. Re-fit the upper door and the upper hinge. Ensure that the door is aligned horizontally and vertically so that the seals are closed on all sides, before finally tightening the upper hinge screws.
4
INSTALLATION 1. Slowly and carefully slide the appliance into the kitchen cabinet. Ensure that the opening side is as close to the cabinet wall as possible.
2. Screw a guide to the side of the appliance door, using 2 short screws. Insert a slider into the guide then fully open and close the appliance and cabinet doors together to check that the cabinet door opens smoothly and can be fully closed.
3. Open the appliance and wooden doors together and mark the position of the slider (approx. 2cm in from the edge of the cabinet door), such that the slider engages with the guide when the door is opened and closed. Take the slider out of the guide and fix the slider to the cabinet door with 2 short screws. Fix the slider cover onto the slider. 4. Unscrew the guide from the appliance door. 5. Repeat steps 2 to 4 to fix the other 3 sliders and covers to the cabinet doors. 6. Fit the 4 guides onto the sliders and then fix then to sides of the appliance doors. Fit the guide covers onto the guides.
5
7. Double check that the doors can close and open smoothly and that the appliance is sealed well. If not, slightly adjust the unit. Fix the bottom bracket to the kitchen cabinet with 2 long screws.
8. Fix the top bracket to the kitchen cabinet with short screws.
9. Insert the rubber seal into the gap between the appliance and the kitchen cabinet, on the door opening side.
10. Fix the middle brackets to the kitchen cabinet, on both sides. Fit the middle bracket covers to the middle brackets.
6
OPERATION BEFORE USING YOUR FRIDGE FREEZER 1. Ensure that the appliance has been installed as recommended and that it is level. 2. Clean the inside of the fridge and freezer compartments (see ‘Care and Maintenance’) 3. Ensure that the appliance has been left for a minimum of 2 hours before switching on the power, to allow the refrigeration system to stabilise. 4. Insert the plug into a socket and switch on the supply. 5. Run the appliance for 2 – 3 hours to allow the compartment to get down to temperature, before placing food in the freezer compartment. Caution: When the compressor first starts up it may produce some background noise. This is normal and will reduce as the cooling system operates.
CONTROL PANEL
Buttons B1 – Press to adjust the temperature of the fridge compartment, scrolling through 2, 3, 4, 6 and 8°C B2 – Press to select the operation mode; Smart, Super or user’s setting. Indicators L1 – Shows the set temperature of the fridge compartment. L2 – Shows that Smart mode has been selected. L3 – Shows that Super mode has been selected.
7
Temperature Setting 1. Press the Mode button to select the user’s setting (Smart and Super indicators off) 2. Press the Adjust button to select the set temperature for the fridge. The temperature of the freezer compartment is automatically controlled at around -18°C. Smart Mode Press the Mode button to select Smart mode. In Smart mode the appliance runs automatically according to the ambient temperature around the appliance. Super Mode Press the Mode button to select Super mode. In Super mode the appliance runs so that the freezer compartment is the coldest. After 54 hours the original fridge temperature setting will automatically be restored. Turn off the Appliance Press and hold the Adjust button for 5 seconds to turn the appliance off. Press the button again to turn the appliance on. Door Open Alarm The alarm will sound if the fridge door is left open for 90 seconds and will continue until the door is closed.
FRIDGE COMPARTMENT
Movable Shelves The walls of the fridge compartment are equipped with a series of runners so that the glass shelves can be positioned as desired. Door Balconies To allow the storage of food packages of various sizes, the door balconies can be removed. To remove the door balcony gently push the balcony upwards until it becomes free.
8
Daily Use x Do not put hot food into the fridge. x Do not place food products directly against the rear wall. x Do not pack food close together as this prevents air circulating. x Do not set the fridge temperature lower than necessary. x Cover or wrap up the food, particularly if it has a strong flavour. x Meat should be stored in sealed plastic bags and placed on the glass shelf above the vegetable drawer. x Cooked food and cold dishes should be covered and stored on any shelf. x Vegetables should be cleaned and stored in one of the drawers. x Butter and cheese should be stored in sealed containers or wrapped in aluminium foil or polythene bags to exclude as much air as possible. x Milk bottles should have a cap and be stored in the door balconies. x Bananas, potatoes, onions and garlic must not be kept in the fridge unless in a fully sealed container.
FREEZER COMPARTMENT Daily Use x The freezer compartment is suitable for freezing fresh food and for storing frozen food. x The maximum amount of fresh food that can be frozen in 24 hours is 3kg. x Do not place carbonated or fizzy drinks in the freezer compartment as the pressure in the container may cause it to explode. x Ice lollies can cause frost burns if consumed straight from the freezer. x Store pre-frozen food as soon as possible after purchasing. x Ensure that the freezer door is always securely closed and only opened for as short a time as possible. x It is recommended that dates are put on the food packages so that the storage time can be monitored. x Ice cubes can be made in the ice tray provided. x Ensure that pre-frozen food is still frozen when it is stored in the freezer. x Cooked food should be allowed to cool to room temperature before placing in the freezer. x Food should be stored in freezer bags or freezer proof containers. x Distribute fresh food evenly in the compartment so that air can circulate. x Do not re-freeze food that has thawed out, unless you cook it again to kill off harmful bacteria. x Reseal packs properly after removing items. This will help prevent the items from drying out and frost building up on any remaining food. x Ensure that the seal is kept clean and that a good seal forms when the door is closed.
9
TECHNICAL SPECIFICATIONS
Energy efficiency class Annual energy consumption (kWh/ annum) Storage Volume (fridge) (litres) Storage volume (4* freezer) (litres) Freezing capacity (kg/24h) Climate class Airborne acoustical noise emissions (dB (A)) Installation
FF250IHE A+ 263 181 63 3 SN, N, ST 4 Built-in
CARE & MAINTENANCE Warning: Always unplug the appliance before cleaning or defrosting the freezer. For hygienic reasons the appliance interior, including the interior accessories, should be cleaned regularly. Cleaning Your Fridge Freezer x Note: Ethereal oils and organic solvents can attack plastic parts. e.g. lemon juice or the juice from orange peel, butyric acid or cleansers that contain acetic acid. Do not allow such substances to come into contact with the appliance parts. x Do not use any abrasive cleaners. x Wash the inside compartments and accessories with warm water and a mild detergent solution. x The outside of the appliance can be cleaned with a damp cloth containing mild detergent and warm water. x Thoroughly dry the interior and exterior of the appliance. x Ensure that the rubber seals on the doors are cleaned regularly, so that a good seal is maintained and the appliance runs efficiently. x To avoid defrost water overflowing into the fridge, periodically clean the drain hole at the back of the fridge compartment. Use a pipe cleaner to clean the hole as indicated below.
10
Replacing the Lamp WARNING: Turn off the supply and unplug the appliance before replacing the lamp. 1. Turn off the mains supply and unplug the appliance. 2. Remove the screw from the lamp cover. 3. Remove the lamp cover. 4. Unscrew the lamp. 5. Fit the new lamp (Max 15W) 6. Refit the lamp cover and screw. 7. Plug in the appliance and switch on the mains supply. Select the required mode or temperature setting.
Defrosting Your Freezer Over time frost will build inside the freezer compartment. At least once a year the freezer will need to be defrosted to ensure that the freezer is working efficiently. Defrosting is better to be done when the stock of frozen food is low. WARNING: Turn off the supply and unplug the appliance before defrosting the freezer. x Remove all frozen food from the freezer compartment and place it in a cooler. Wrapping the food in newspaper will help to keep it frozen. x Switch off the mains and unplug the appliance. x Place a container under appliance to collect the defrost water. x Carefully remove the ice layer with an ice scraper. Do not use sharp metal tools. x Leave the door open to allow the ice to thaw. x Warm (not boiling) water can be poured onto the ice to speed up the defrosting process. x Once all the water has drained out, clean and thoroughly dry the freezer compartment. x Plug in the appliance and switch on the mains supply. x Run the freezer for at least an hour before returning the frozen food to the compartment.
11
Power Failure x If the mains power should go off, avoid opening the doors so that the interior remains as cool as possible. x The food inside the freezer should remain frozen as long as the power is off for less than 24 hours. x If the power is due to be off for more than 24 hours then the frozen food should be quickly moved to another freezer.
CUSTOMER SERVICE If you have a problem with your appliance please check the troubleshooting guide below, before calling for a Service Engineer. Please ensure that you have the model number and your serial number to hand when you make the call. For UK and Southern Ireland call: 0800 988 1323 or (Calls are FREE from landlines, however calls from mobiles may be charged at your network provider’s rates)
Either
03448 797422 (Calls charged at basic rate)
For Northern Ireland call: 028 90365222 (Service Network 2000) (Daytime calls cost up to 17p plus 10p per minute from BT lines Monday-Friday. Mobile and other providers’ charges may vary). Please note: If the fault is caused by customer misuse or is due to faulty installation, you will be charged for the call-out.
12
TROUBLESHOOTING GUIDE In the unlikely even of a problem with your fridge freezer, please consult the guide below before calling a Service Engineer.
PROBLEM
Appliance does not operate
Food is too warm
Noisy appliance
Water on the floor
POSSIBLE CAUSE Appliance not plugged in or mains not switched on. The fuse or circuit breaker has operated. Appliance is turned off. Press ‘Adjust’ button for 5 seconds to turn appliance on. Temperature is set too high. The door has been frequently opened. The rubber seal is not sealing properly. A large amount of fresh food has recently been added. Vibrations caused by objects touching the appliance. Vibrations caused by the appliance not being stable or level. Popping, cracking or gurgling sounds from the refrigeration circuit are normal. Drain hole in the fridge compartment is blocked.
13
DISPOSAL INFORMATION This appliance is marked according to the European Directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). At end of life this product should be recycled and not disposed in household waste. Contact your retailer, council or local authority for further information.
Old refrigeration appliances are likely to contain CFC gases which are harmful to the environment. Please ensure that you dispose of old appliances responsibly.
14
Supplied by Crosslee plc, Halifax, West Yorkshire, HX3 8DE
CKWK-G01-B
