Transcript
Fiber2Home DFTC
Features
Dual speed fiber, triple speed copper media converter
• 100/1000Base-Fx auto-sensed
Now you can easily migrate from 100Mbit fiber to gigabit without changing customer premise equipment (CPE). Start using the new Fiber2Home DFTC in your current 100Mbit infrastructure. When you are ready to move to gigabit, only change the central switch and all the CPE:s will automatically adjust to gigabit speed. This cuts the number of customer visits in half and reduce your installation cost with 50%. No need for proprietary equipment, its compatible with your existing Ethernet products and follows all the accepted standards. Enjoy the first media converter on the market with dual speed fiber and make major savings in installation cost.
• Support full/half duplex autosensed
• 10/100/1000Base-Tx auto-sensed • High compatibility capacity: compatible with the network card, hub, switch and repeater of other brands
• Support MDI/MDI-X auto-sensed • Support the transmission of VLAN extra-long data package • Support the transmission of QoS packets • Support the transmission of VoIP packets
tel. +46 (0)8-524 00 700 www.direktronik.se PART OF LAGERCRANTZ GROUP
meters
Technical Parameters Advantage
Fiber Interface
• Auto-sense the rate(100 or 1000) of fiber
SFP module, fixed fi ber
• Facilitate the upgrade of the network, save the cost
Connector: LC(default), SC
• Facilitate to keep the consistence of the products and the whole system
Full/half duplex auto-sensed
• Meet the different requirement of bandwidth for end-users
UTP Interface
Rate: 100/1000M auto-sensed Fiber: Multi-mode: 50/125, 62.5/125; Single mode: 8.3/125, 8.7/125, 9/125or10/ 125µm Power Supply: external power: AC 110~265V/ DC-48V input;
Connector: RJ 45 Rate: 10/100/1000M auto-sensed MDI/MDI-X auto-sensed Cat.5 UTP cable
DC5V 2A output
Standards
Relative Humidity: 5%~90%
Working Temperature: 0°~60°
Complies with IEEE802.3, IEEE802.3u, IEEE802.3z, IEEE802.3ab standards and supports the connection between 10Base-T, 10Base-TX, 1000Base-T, 100Base-SX/LX and 1000Base-SX/LX Marking
LED status
Meaning
Power
Always on
Power supply on
Off
Power supply off
Always on
Connected at 100 Mbps
Off
Connected at 10 Mbps
Always on
A correct network connection has been established
Flashing
Receiving or sending data. ACT means ACTIVITY
Always on
Connection at full duplex
Flashing
Collisions occurring
Off
Connection at half duplex
Speed LNK.ACT
TX=copper FX=Fibre LNK means LINK
FDX/COL FDX means FULL-DUPLEX COL means COLLISION
Fig. 1 Converter Structure
UTP Interface part
SPEED
POWER
FDX/COL
FDX/COL
LNK/ACT
LNK/ACT
LED Indicator part
Protocol conversion Part
Detection Part
Fiber Interface part
tel. +46 (0)8-524 00 700 www.direktronik.se PART OF LAGERCRANTZ GROUP
