Finisar Ftlc1151sdpl 100gbase-lr4 And Otu4 10 Km Qsfp28

Transcript

Product Specification 10km Multi-rate 100G QSFP28 Optical Transceiver Module FTLC1151SDPL PRODUCT FEATURES  Hot-pluggable QSFP28 form factor  Supports 103.1Gb/s and 112Gb/s aggregate bit rates  Power dissipation < 3.5W  RoHS-6 compliant  Commercial case temperature range of 0°C to 70°C  Single 3.3V power supply  Maximum link length of 10km on Single Mode Fiber (SMF) APPLICATIONS  4x28Gb/s DFB-based LAN-WDM transmitter  OTN OTU4 4I1-9D1F  4x28G retimed electrical interface  100GBASE-LR4 100G Ethernet  Duplex LC receptacles  I2C management interface Finisar’s FTLC1151SDPL QSFP28 transceiver modules are designed for use in 100 Gigabit Ethernet and 4x28G OTN client interfaces over single mode fiber. They are compliant with the QSFP28 MSA1, IEEE 802.3ba 100GBASE-LR42 and OTU4 4I19D1F requirements specified in ITU-T Recommendations G.959.1/G.709 and Supplement 39 (G.sup39). Digital diagnostics functions are available via the I2C interface, as specified by the QSFP28 MSA and Finisar Application Note AN-21525. The transceiver is RoHS-6 compliant per Directive 2011/65/EC4 and Finisar Application Note AN-20385. PRODUCT SELECTION FTLC1151SDPL S: D: P: L: OTU4 maximum bit rate (112 Gb/s) 4x28G LAN-WDM optical architecture Pull-tab release LC straight receptacles  Finisar Corporation –7-May-2016 Rev. B1 Page 1 FTLC1151SDPL Product Specification – May 2016 I. Pin Descriptions Figure 1 – QSFP28-compliant 38-pin connector (per SFF-8679) Pin 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 Symbol GND Tx2n Tx2p GND Tx4n Tx4p GND ModSelL ResetL Vcc Rx SCL SDA GND Rx3p Rx3n GND Rx1p Rx1n GND GND Rx2n Rx2p GND Rx4n Rx4p GND ModPrsL IntL Vcc Tx Name/Description Ground Transmitter Inverted Data Input Transmitter Non-Inverted Data Input Ground Transmitter Inverted Data Input Transmitter Non-Inverted Data Input Ground Module Select Module Reset +3.3 V Power supply receiver 2-wire serial interface clock 2-wire serial interface data Ground Receiver Non-Inverted Data Output Receiver Inverted Data Output Ground Receiver Non-Inverted Data Output Receiver Inverted Data Output Ground Ground Receiver Inverted Data Output Receiver Non-Inverted Data Output Ground Receiver Inverted Data Output Receiver Non-Inverted Data Output Ground Module Present Interrupt +3.3 V Power supply transmitter  Finisar Corporation –7-May-2016 Rev. B1 Notes 1 1 1 1 1 1 1 1 1 Page 2 FTLC1151SDPL Product Specification – May 2016 30 31 32 33 34 35 36 37 38 Vcc1 LPMode GND Tx3p Tx3n GND Tx1p Tx1n GND +3.3 V Power Supply Low Power Mode Ground Transmitter Non-Inverted Data Input Transmitter Inverted Data Input Ground Transmitter Non-Inverted Data Input Transmitter Inverted Data Input Ground 1 1 1 Notes 1. Circuit ground is internally isolated from chassis ground. II. Absolute Maximum Ratings Module performance is not guaranteed beyond the operating range (see Section VI). Exceeding the limits below may damage the transceiver module permanently. Parameter Maximum Supply Voltage Storage Temperature Case Operating Temperature Relative Humidity Receiver Damage Threshold, per Lane Symbol Vcc TS TOP RH PRdmg Min -0.5 -40 0 15 5.5 Typ Max 3.6 +85 +70 85 Unit V C C % dBm Ref. 1 Notes: 1. Non-condensing. III. Electrical Characteristics (EOL, TOP = 0 to +70 C, VCC = 3.135 to 3.465 Volts) Parameter Supply Voltage Supply Current Module total power Transmitter Signaling rate per lane Differential data input swing per lane Differential input return loss (min) at LR4 Differential to common mode input return loss (min) at LR4 Differential input return loss (min) at OTU4 Different to common mode input return loss (min) at OTU4 Differential termination mismatch Stressed input parameters Eye width Applied pk-pk sinusoidal jitter Eye height DC common mode voltage Symbol Vcc Icc P Min 3.135 Typ Max 3.465 1.12 3.5 25.78 Vin,pp RLd(f) RLdc(f) SDD11 SDC11 SCD11  Finisar Corporation –7-May-2016 Rev. B1 27.95 900 9.5 – 0.37f, 0.01≤f<8 4.75 – 7.4log10(f/14), 8 ≤f<19 22-20(f/25.78), 0.01≤f<12.89 15-6(f/25.78), 12.89≤f<19 -11, 0.05