Preview only show first 10 pages with watermark. For full document please download

Finisher Unit Installation Guide

   EMBED

Share

Transcript

Finisher Unit Installation Guide Components 4 1 3 2 7 5 2. Using a screwdriver, remove the breakout panels on the side of the printer. 6 1. Finisher unit 2. Finisher stand 3. Inverter unit 4. Stacking tray 5. Rear cover 6. Clear band 7. Band stopper (2) 3. Open the face-up stacker. Prepare the Printer 1. Turn the printer off and disconnect the power cord and interface cable. 4. Open the flap and press it onto the stacker surface 5. Close the stacker. 2. Hook the finisher stand to the inverter. 6. Install the metal brackets as shown. Assemble the Finisher 3. Attach the finisher stand to the inverter with 2 screws. 1. Attach the guide rail of the inverter to the printer with 2 screws. 4. Slip one end of the clear band over the tab on the right side of the rear cover at a right angle. 2 9. Loosen the screw on the locking piece so that it drops through the slot below. This keeps the platform from moving while you attach the finisher to it. 5. Slip the other end of the band through the retainer on the finisher, then secure it with the smaller stopper. 6. Turn the cover so it faces the finisher. 7. Place the larger stopper over the tab and turn to lock it in position 10.Position the finisher on the stand and attach it with two screws from the back. 8. Attach the rear cover to the finisher and close it. 11.Swivel the locking piece up and tighten the screw firmly. Be sure it’s out of the way and the screw is tight—otherwise the platform will not move freely. 3 Complete the Assembly 12.Position the stacker on the back of the finisher with the hooks engaged. Leveller 13.Make sure the lever on the finisher is positioned above the stacker. 14.Attach the stacker with four screws. © 2005 Oki Data Americas, Inc. 1. Push the finisher against the printer until the prongs on the printer brackets fit into the holes in the finisher. 2. If you need to, turn the levellers on the finisher to raise or lower the finisher so the holes and prongs align properly. Make sure the finisher is level. 3. Connect the printer and the finisher to the inverter, and connect the inverter’s power cord. 58372801