Firewirevr Quick Installation Sheet

Transcript

3. Package Contents FireWireVR Quick Installation Sheet Thank you for choosing CalDigit. This quick installation sheet is for reference only. Please check the detailed manual on the provided CD, and also check our website at www.caldigit.com for updated drivers/softwares. • • • • • • • One unit of FireWireVR 2 Hard drives in tray module FW 800, 9pin – 9pin cable Archive Box Flat Blade Screw Drive (RAID changing) Installation CD & Quick Installation Sheet AC Power Adapter & Power Cord turn the screwdriver handle to the left or right to select a different mode. 3. Turn on the FireWireVR and verify the RAID setting. 4. FireWireVR Interface: 1. Product Specification: Physical Dimensions: Power: Operating temperature: Weight (net): 9.76" L X 5.12" W X 4.26" H / 247.87mm L X 130mm W X 108mm H 100-240V auto switch 50~64Hz 1.5A, Output 5V 4.2A, 12V 3A 0-40 degrees C or 32° to 104°F 7.5lb / 3.4kg 6. RAID Changing (Windows): 1. Please use the 3-Steps Easy RAID Configure. 2. Windows will mount the FireWireVR. 2. System Requirements: Windows Requirements: • P-III or higher with FireWire 800 / USB 2.0 interface card. (For FW800 / USB 2.0) • 128MB RAM or higher • Windows 2000 SP4 or Windows XP SP1 • P-II or higher with FireWire 400 / iLink interface card. (For FW400 / iLink) • 64MB RAM or higher • Windows 2000 / Windows XP Mac Requirements: G4 / G5 with FireWire 800 / USB 2.0 interface. (For FW800 / USB 2.0) OS 10.2.4 or higher. • • G3 or higher with FireWire 400 / iLink interface. (For FW400 / iLink) • OS 9.X and OS 10.X 3. Open Administrative Tools in Control Panel. • Copyright © 2006, CalDigit, Inc. All rights reserved S2VR Duo S2VR HD, S2VR Pro, CalDigit name and logo are registered trademarks of CalDigit Inc. All other trademarks are the property of their respective holders. 5. 3-Steps Easy RAID Configure: 1. Turn off your FireWireVR 2. Insert the provided flat-blade screwdriver into the groove on the rotary switch and 4. Open Disk Management in Admin. Tools. 7. RAID Changing (MAC): 1. Please use the 3-Steps Easy RAID Configure. 2. System message appear, click Initialize. 5. Partition the FireWireVR drive in Disk Mgmt. **Please note that the FireWireVR will serve as enclosure for two separated hard drives under JBOD mode. 3. Open the Disk Utility. **Please perform the previous steps for both hard drives. 8. Safe Mode Rebuild: • In the event of drive failure, FireWireVR will automatically check and rebuild the information from the other drive. • CONGRATULATIONS! 6. Verify the information on Disk Management. 4. Create a partition for the FireWireVR. **Please note that the FireWireVR will serve as enclosure for two separated hard drives under JBOD mode. **Please perform the previous steps for both hard drives. 5. Your FireWireVR is ready to use. Your FireWireVR is ready to use! Thank you for your purchase. Please visit us at www.caldigit.com for updated drivers and information on new CalDigit products.