Preview only show first 10 pages with watermark. For full document please download

For The Kuma Wifi Booster Kit Quick Start Guide Click Here

   EMBED

Share

Transcript

WiFi Booster kit Quick Start Guide Plug the Edup wireless antenna into the USB socket on the front of the repeater using the USB lead supplied. Screw the small antenna on to the rear of the repeater and power up the using the 240v AC or 12v DC lead supplied. Connect your WiFi on your device to the ‘11N 3G Router AP’ signal. At this point no password is required to connect Open a browser on your device (smartphone/tablet/computer) and in the address bar type 192.168.2.1 When prompted enter User name = admin Password = admin The Repeater will then display the Start-up screen To connect via WiFi Plug your WiFi antenna into your repeater box using the USB connector on the front of the box Select ‘Easy Setup’ and click on the ‘USB Wireless Adapter’ button. Next Click the Site Survey button in the middle of the screen above and wait until all the available networks are shown in a list. You can arrange them by signal strength if you wish, or by name, simply by clicking on the headings on the screen below. Select the wireless network you wish to connect to, and then click ‘Select’. If the wireless network has a password, enter it in the ‘Pass Phrase’ box at the bottom of the screen and then click ‘Next’ You are now connected to the remote network. If you wish to add a password to the 11N 3G USB router connection (highly recommended), you can do so on the screen below. Select “Security Mode” then WPA2PSK (this is the most secure), select the AES button on the WPA section and enter a password between 8 and 63 characters. The device will re-boot when you click ‘Done’ and don’t forget if you have set up a password at the end, you will need it to connect your device to the repeater when it has started again. After re-boot check the USB LED is on and off you go! To Connect via 3G Plug in your dongle with its SIM card Select ‘Easy Setup’ and click on the ‘3G dongle’ button.