Transcript
http://www.kb2ljj.com/data/yaesu/ft-5200.txt
YAESU FT-5200 cross band mod. ----------------------
www.r6-ru4montesecchieta.it IZ5CCV
1. 2. 3. 4. 5.
Disconnect power from radio. Unlatch and remove the front control head. Remove (6) screws from top cover of radio. Remove (6) screws from bottomcover of radio. Remove top and bottom cover, being careful for the speaker --that will want to fall out. 6. Remove the (2) silver screws (on each side of radio) holding front control --head mounting plate to main body of radio. Removethe front mounting plate. 7. Locate and unsolder jumper pad 17. 8. Install thefront mounting plate, and top and bottom covers. 9. Reconnect power. 10. To put in xband repeat press and hold the RPT key while turning on the --radio. To stop... turn off the radio.
Notes: It is suggested to disconnect the mic when in xband repeater, as it will be "hot". Adjust the volume knob for the desired repeat audio level. This might seem confusing when first viewing the jumper pads... they are to the right of the 5 strip connector for the face plate and are numbered as follows: .. 20 18 16 14 12 10 8 6 4 2 .. 19 17 15 13 11 09 7 5 3 1 You will see that the number 17 is lower than the rest and that there are 2 pads above it.. one in line with all the others (this is the correct one) and one that is horizontal and just above the number "17" (this should be left alone). There are certain frequency combinations that just don't work,and http://www.kb2ljj.com/data/yaesu/ft-5200.txt (1 di 2)08/09/2009 23:27:01
http://www.kb2ljj.com/data/yaesu/ft-5200.txt
others that require one, the other, or both sides to transmit at low power.
FT5200 extended frequency range mod. -----------------------------------See above for jumpers location. Short jumpers from 1 to 7 as following: for VHF: 1, 2 and 3. for UHF: 6 and 7. Push at the same time D/MR, F/W and REV while switching tranceiver ON. Now program: vhf low rx freq., push D/MR " hi " " , " " " low tx " , " " " hi " " , " " and the same for uhf. You can try 135 to 185 and 420 to 460 MHZ. FT5200 at 9600 bauds -------------------If you have the mod, please send it to me ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ» º KB2LJJ BBS RADIO MODS BATABASE º by packet. ÈÍÍÍÍÍÍÍÍÍÍÍ» ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ responsability or ÉÍÍÍÍÍÍÍÍÍÍͼ ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ» resulting º KB2LJJ @ KB2LJJ.NJ.USA.NA º ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ
http://www.kb2ljj.com/data/yaesu/ft-5200.txt (2 di 2)08/09/2009 23:27:01
All the MODS are captured This BBS takes no liability for any damege from any modification. 73s John kb2ljj SySoP
