Transcript
FTS 370 Vanguard Catenary LED Lighting System
The Vanguard® FTS 370 Catenary is an FAA L866/L885 catenary lighting system that is available in Dual, White, or Red LEDs. Specifically designed for marking structures that support transmission lines that span across low terrain such as waterways, ravines and gorges. The flash sequence is middle, top, bottom at 60 flashes/min. TOP BEACON
TOP BEACON
STANDARD FEATURES ìì Long LED life through By-pass Circuitry and Interleaved strings
MID BEACONS
MID BEACONS LOWER BEACON TO MATCH CABLE HEIGHT
BOTTOM BEACONS
BOTTOM BEACONS
1. FLASHING SEQUENCE: MID, TOP, BOTTOM 2. TOP LIGHT MARKS HIGHEST POINT OF STRUCTURE BOTTOM LIGHT MARKS LOWEST POINT OF CABLE
ìì Industry leading IEC 61000-4-5 Surge Immunity to 25kA ìì Patented Fresnel Optics to minimize ground scatter ìì 4-line OLED backlit display for visibility in any lighting conditions ìì Automatic Failsafe—switches to day mode after 19 hours of no mode change. Can be disabled if necessary ìì Configurable to meet AC 70/7460-1L ìì Monitoring—Dry Contacts (Day, Night, Marker, PED, GPS, Comm alarms, and Mode status)
FTS 370 Vanguard Catenary
OPTIONAL FEATURES ìì Infrared Lighting - NVG and NVIS compatibility using 850nm Infrared (IR) LEDs ìì SMART Card - Enables several options for monitoring and controlling the system remotely while providing full diagnostic information using either cellular or ethernet based connectivity. The following protocols are supported: · SNMP v2c, v3 · Modbus RTU Serial/TCP, TCP/IP · Eagle by Flash Technology ìì Wi-Fi - Provides wireless connectivity onsite for diagnostics and lighting inspections
Flash Technology, LLC 332 Nichol Mill Lane Franklin, TN 37067-8203 USA T +1 615 503 2000 T +1 888 313 5274 F +1 615 261 2600 flashtechnology.com
4
ìì GPS Synchronization ìì Remote Updgradeable Firmware FTS370c-030416
GENERAL SPECIFICATIONS
Data and specifications subject to change without notification.
© 2016 Flash Technology, LLC All rights reserved. Input Voltage
100-240 VAC ±24 VDC (optional) ±48 VDC (optional)
Frequency
50-60 Hz
FH Dimensions
15.75” dia. x 7.31”
FH Weight
26.3 lbs. (11.92 kg)
FH Aerodynamic Wind Area
99.125 in2
Controller Dimensions
23” x 17.13” x 6.44”
Controller Weight
44 lbs. (20 kg)
System Power Consumption
See Chart Below
Protection Rating
IP65, NEMA 4X
Certifications
L-866 L-885
Power Consumption (with IR)
Flash Rate (per min)
Flash Intensity
Day (white) 110w (100w)
60 flashes
20,000 ±25% ECD
Night (red)
50w (50w)
60 flashes
2,000 ±25% ECD
Night (white) 50w (50w)
60 flashes
2,000 ±25% ECD
SPX Corporation Global Industrial Equipment & Global Manufacturing spx.com
