Transcript
INSTALLATION INSTRUCTIONS
FVS100
FVS150
Lower Video Conference Camera Shelf Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description
FVS100 / FVS150
FVS100 / FVS150
Installation Instructions
DISCLAIMER Milestone AV Technologies and its affiliated corporations and subsidiaries (collectively "Milestone"), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document. Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
IMPORTANT WARNINGS AND CAUTIONS!
CAUTION: A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the corresponding instructions.
WARNING: Failure to read, thoroughly understand, and follow all instructions can result in serious personal injury, damage to equipment, or voiding of factory warranty! It is the installer’s responsibility to make sure all components are properly assembled and installed using the instructions provided.
WARNING: Failure to provide adequate structural strength for this component can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the structure to which this component is attached can support five times the combined weight of all equipment. Reinforce the structure as required before installing the component.
WARNING: Exceeding the weight capacity can result in WARNING: A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions.
serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the combined weight of all components located on the FVS100/FVS150 does not exceed 10 lbs (4.5 kg).
LEGEND
2
Tighten Fastener
Pencil Mark
Apretar elemento de fijación
Marcar con lápiz
Befestigungsteil festziehen
Stiftmarkierung
Apertar fixador
Marcar com lápis
Serrare il fissaggio
Segno a matita
Bevestiging vastdraaien
Potloodmerkteken
Serrez les fixations
Marquage au crayon
Loosen Fastener
Phillips Screwdriver
Aflojar elemento de fijación
Destornillador Phillips
Befestigungsteil lösen
Kreuzschlitzschraubendreher
Desapertar fixador
Chave de fendas Phillips
Allentare il fissaggio
Cacciavite a stella
Bevestiging losdraaien
Kruiskopschroevendraaier
Desserrez les fixations
Tournevis à pointe cruciforme
Installation Instructions
FVS100 / FVS150
DIMENSIONS FVS100 USABLE SHELF DEPTH 11.2" - SCREEN DEPTH WEIGHT CAPACITY 10 LBS. 50.8 2.00
50.8 2.00 141.6 5.57
88.9 3.50
7.1 .28
88.9 3.50
CENTERLINE OF MOUNT
22.2 .88
88.9 3.50
27.3 1.07
203.2 8.00 137.2 5.40
344.5 13.56 MINIMUM EXTENSION
288 11.34
308.3 12.14
40.8 1.60
500.1 19.69 MAXIMUM EXTENSION
335.3 13.2
11.9 .47
FVS150 305 12.00
USABLE SHELF DEPTH 11.2" - SCREEN DEPTH WEIGHT CAPACITY 10 LBS.
51 2.00
127 5.00 51 2.00 141.6 5.57
27.3 1.07
101 3.96
152 6.00
CENTERLINE OF MOUNT
88.9 3.50
89 3.5
89 3.5
346 13.64 MINIMUM EXTENSION
7 .28
331 13.01
256 10.06
16 .61
137 5.40
335 13.2
411 16.19
500 19.69 MAXIMUM EXTENSION
486 19.14
53 2.07
41 1.60
3
FVS100 / FVS150
Installation Instructions
TOOLS REQUIRED FOR INSTALLATION
#2
PARTS
A (1) B (1)
C (1) [FVS100 only] D (1) [FVS150 only]
E (4) 10-24 x 5/8"
4
F (2) 10-24 x 1"
Installation Instructions
FVS100 / FVS150
Assembly and Installation
3.
Assembling Shelf and Brackets
NOTE: The shelf with hanger bracket may be adjusted up or
1.
Attach lower shelf (C or D) to hanger bracket (B) using four 10-24 x 5/8" Phillips pan head screws (E). (See Figure 1)
Hang shelf with hanger bracket onto the hook bracket (A). (See Figure 3) down on the hook bracket (A) in 7/8" increments for a total height adjustment of up to 6.05".
(B) (A) (E) x 4
1
(C) [FVS100 shown]
Figure 1
Attaching to Wall Mount NOTE: The FVS100/FVS150 may be attached to the wall mount with the display already in place, or with the display removed. Proceed to either Installing to Wall Mount with Display Attached or Installing to Wall Mount with Display Removed section.
Installing to Wall Mount with Display Attached 1.
Pull out bottom of display.
2.
From below and behind the display, raise and hang hook bracket (A) onto lower wall mount rail. (See Figure 2)
[Display shown removed for clarity]
Figure 3
[Display shown removed for clarity]
NOTE: Proceed to Installing Camera section. Wall Mount
Installing to Wall Mount with Display Removed NOTE: Installing the FVS100/FVS150 to a wall mount where a display has been removed allows use of security screws to prevent the FVS100/FVS150 from being removed. 1.
Hang shelf with hanger bracket onto the hook bracket (A). (See Figure 4)
(A)
Figure 2
5
FVS100 / FVS150
Installation Instructions 5.
Hang display on wall mount following installation instructions included with the wall mounts.
Installing Camera (A)
1.
Install camera to shelf.
NOTE: If camera has a bottom mounting screw, attach it through the mounting slot in the shelf. (See Figure 6) 2.
1
Route cable from camera. (See Figure 6)
NOTE: Cable may be routed using the cable clip on the underside of the shelf. Secure the cable at the cable clip with a wire tie (not included). (See Figure 6)
Shelf with hanger bracket
[FVS100 shown]
Figure 4 NOTE: The shelf with hanger bracket may be adjusted up or down on the hook bracket (A) in 7/8" increments for a total height adjustment of up to 6.05". 2.
Remove display if already attached to wall mount following instructions included with the wall mount.
3.
Hang FVS100/FVS150 on lower wall mount rail.
4.
Adjust location and secure to wall mount rail using two 10-24 x 1" Phillips pan head screws (F). (See Figure 5)
Cable Clip
Routing Cable Camera Mounting Slot
Figure 6
4
(F) x 2
Figure 5
6
Installation Instructions
FVS100 / FVS150
7
FVS100 / FVS150
Installation Instructions
USA/International
Europe Chief Manufacturing, a products division of Milestone AV Technologies 8807-000081 Rev01 2009 Milestone AV Technologies, a Duchossois Group Company www.chiefmfg.com 01/09
Asia Pacific
A P F A P F A
8401 Eagle Creek Parkway, Savage, MN 55378 800.582.6480 / 952.894.6280 877.894.6918 / 952.894.6918 Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands +31 (0)40 2668620 +31 (0)40 2668615 Room 24F, Block D, Lily YinDu International Building LuoGang, BuJi Town, Shenzhen, CHINA.
P +86-755-8996 9226 F +86-755-8996 9217
