Transcript
Page 1 of 2
FYI® Dual Monitor Arm
FYI Dual Monitor Arm FPADUALCC FPADUALTM
Installation Instructions 004166D Rev E
Tools:
(Not all tools required for each mounting option)
6
#2 Phillips Screwdriver
6 5 Power Drill
5 See note below
11/32" Dia. Drill Bit
7
1/16", 5/32" & 1/4" Allen Wrench
7 5/16 Wrench
1 6 4
2
Attach base assembly to worksurface.
Attach base assembly to worksurface.
3
Drill 11/32” hole
3
1
4 NOTE: Located in Monitor Arm Hardware Pack.
FYI® Dual Monitor Arm | Installation Instructions
2
Page 2 of 2
004166D Rev E FYI Dual Monitor Arm FPADUALCC FPADUALTM
1
2
Attach VESA Bracket to backside of monitor.
Slide monitor mount assembly onto end of arm until audible “click” is heard. Tighten set screw to prevent removal of monitor.
Tools Required: • 1/16” Allen Wrench • 5/16” Wrench
release mechanism
set screw To remove, loosen set screw, depress and hold release mechanism while lifting monitor up and off arm.
3
Gently pry off cable cover on the bottom of the arm. Insert cables into arm cavity and through two loops under the arm. Press cover back into place.
4
Adjust T-handle to accommodate weight of monitor. The monitor should “float” (neither rise nor fall when the counterbalance is properly adjusted). • If monitor sinks when installed, pull up the T-handle and turn clockwise until monitor “floats”. • If monitor rises when installed, pull up the T-handle and turn counter-clockwise until monitor “floats”.
T-handle insert cables
cable cover
cable cover
While adjusting the T-handle, the upper arm should be nearly horizontal, to allow the T-handle to turn freely. If resistance is encountered, raise or lower upper arm, until the T-handle begins to turn easily.
For further information, please go to the Details website details-worktools.com or call 800.833.0411 P.O. Box 1967 / CD-5E Grand Rapids, MI 49501-1967 ©2012 Steelcase Inc. All rights reserved. 12/12
