Preview only show first 10 pages with watermark. For full document please download

G4000n Cabling System Adapter For Wiremold ® G4000 Raceway

   EMBED

Share

Transcript

Cabling network adapter covers. NOT SUPPLIED—AVAILABLE SEPARATELY G4000N Cabling System Adapter For Wiremold® G4000 Raceway Systems RSN TTN CCN C4N I4N TCN T4N DEC INSTALLATION INSTRUCTIONS Wiremold Electrical Systems conform to and should be properly grounded in compliance with requirements of the current National Code or codes administered by local authorities. All electrical products may represent a possible shock or fire hazard if improperly installed or used. Wiremold electrical products are UL listed, made for interior use in dry locations only and should be installed in conformance with current local and/or the National Electrical Code. TO INSTALL CABLING ADAPTER: Key Mounting Cover Fig. 2 Adapter* Fig. 1 1. To snap adapter onto 8" mounting cover, engage one tab under lip of cover, push sideways and down (in all the way). Note: Adapter holecut is offset in the cover to allow assembled connector to clear divider where applicable. Fig 3 2. Snap adapter locking key into front of adapter. Fig. 4 Fig. 3 3. Adapter Guard — OPTIONAL. Drill mounting holes prior to attaching mounting cover. Align holes of the adapter guard with the holes in the cover and secure screws. 4. Snap cover assembly onto raceway. TO REMOVE CABLING SYSTEM ADAPTER: Fig. 5 1. Remove screws from adapter cover/guard and remove cover from raceway. Reverse step 3. 2. Remove connector and modular jack from adapter.* Remove key from connector. Reverse steps 2 and 1. Fig. 6 3. To remove adapter from mounting plate, insert small screwdriver into slot just above ribbed door (Fig. 5). Pry gently to dislodge the key and remove. 4. Deflect retaining tabs from back of mounting cover and remove. (Fig. 6) *IBM ADAPTER SHOWN (I4N) AVAILABLE SEPARATELY The Wiremold Company 60 Woodlawn Street, P.O. Box 332500 West Hartford, CT 06133-2500 Tel. (203) 233-6251 Fax 203-232-2062 40804 494