Preview only show first 10 pages with watermark. For full document please download

Gatr Green Adaptive Transporter Operators Manual

   EMBED

Share

Transcript

GATR Green Adaptive TransporteR Operators Manual Contents • Pages 3 to 5 • Page 6 • Pages 7 to 9 • Page 10 G2 Two Wheel GATR Set Up Front Axle Positions G4 Four Wheel GATR Set Up Add Ons G2 Two-Wheel Set-Up 2. 3. 1. 1. Rear Stand (On/Off) 2. Desired Attachment 3. Front Wheel Positions G2 – Rear Stand Fit-Up (fit up, from the wall mount or upside down) 1. Fit (2) Stand Tabs in green rear cross member slots. 3. Place Hand clamp, carriage bolts thru holes (2). 2. Pivot Stand over fasteners, lying flat. 4. Place hand clamps, plastic hub and hand tighten both clamps snug. Tee bolt clamp slot G2 – Attachment Latching 1. All attachments have a yoke bar with a shoe on one end and a clamp slot on the other. Shoe end 2. Fit shoe into GATR front nose plate slot and set attachment onto the rear clamp down holder. 3. Pivot Tee Bolt Clamp into yoke bar clamp slot. Tee bolt clamp should pivot into yoke stop, crossing the width of the yoke bar. 4. Hand tighten hand tee bolt clamp. Front Wheels 3 Positions (for each attachment) G4 Four Wheel Set-Up 3. 1. Remove G2 Stand 2. Retain (2) G2 Hand Clamps 3. Attach Caster Assembly 2. 1. G4 - Caster Wheel Assembly Fit-Up 1. Set Caster Wheel Assembly, behind GATR Transporter 2. Pivot Caster Upright, and lift GATR, bring together into the Caster Stops. 3. Place carriage bolt thru Caster uprights, rom inside thru center of green handle facing outward (both sides). 4. Slide hand clamp over carriage bolt and hand tighten clamp. G4 Attachment Latching 1. Place Flat Deck front shoe into the GATR front nose plate slot. 2. Pivot Tee Bolt Clamp into yoke bar clamp slot. Tee bolt clamp should pivot into yoke stop, crossing the width of the yoke bar. Hand tighten hand tee bolt clamp. Wall Mounts A) GATR Hanger Brkt, centerline Mounting holes 60” from floor. These holes are drilled at 16” centers For wall stud centerline. B) Attachment Hanger Brkt, top brkt hole from floor set at 40”. G4 Attachments