Glider Board Assembly Instructions

Transcript

GLIDER BOARD Assembly Instructions www.babyjogger.com Box Includes: Read carefully and keep for future reference 1 x Glider Board 2 x Wheels Recommended for children from 2 years of age up to 45 lbs.  WARNING: Always secure seat recline strap by snapping the D-ring to the recline clamp before using the Glider Board. 1 Insert wheel axle into the hole on the underside of the Glider Board. The wheel is secure when you hear it click. Repeat on other side. 2 Slide ratchet straps between the lower support bar and the brake rods. a Attachment Brackets b 3 P ush attachment brackets onto lower support bar until they clip into place. To Adjust Glider Board Angle: 4 P ress ratchet lock tab (a) and slide ratchet strap through opening (b). NOTE: Do not trap brake wire between ratchet strap and lower support bar. 1 2 5 Push ratchet strap through until snug. Repeat on other side. 3 1 Push the safety cover away from the tabs. 2a To Raise: Press gray tabs on right and left side of Glider Board and pull front edge up. 2b To Lower: Press gray tabs on right and left side of Glider Board and push front edge down. 3 Pull the safety cover back over the tabs.  WARNING: NOTE: GLIDER BOARD MUST BE PARALLEL TO THE GROUND OR SLIGHTLY ANGLED TOWARD THE STROLLER BEFORE USE. Depending on your stroller model, you may need to adjust the angle. Always ensure the safety covers are covering the adjustment tabs prior to use. To Adjust Glider Board Length: 1 P ull handle on the rear underside of Glider Board. Pull out to extend. Push in to shorten. Storage (while using the stroller): 1 R aise Glider Board and unhook storage straps from underside. 2H  ook storage straps around rear crossbar of stroller frame. NOTE: When stored, make sure the rear of the Glider Board is not interfering with the back of the stroller seat. Adjust Glider Board length for storage if necessary.  WARNING: Always make sure storage straps are fastened to the underside of the Glider Board before use. Storage (when folding the stroller): 1 T he Glider Board wheels must be removed before you can fold the stroller. Follow steps (1) and (2) of the Gilder Board Storage instructions (above), then remove the wheels. Press wheel release button and gently pull out wheel to remove. To Remove Glider Board: 1 P ress ratchet lock tab and pull ratchet strap out. Unclip attachment brackets.  WARNING: • Always make sure the ratchet straps are securely tightened before use. • The Glider Board is suitable for children from 2 years old up to a maximum weight of 45 lbs (20kg). • Do not run or skate with this product attached to a stroller/pushchair. The sample product shown in this manual may differ slightly from your production quality Glider Board. However, this will not affect the assembly or functionality of your Baby Jogger product. 8575 Magellan Parkway, Suite 1000 • Richmond, VA 23227 • T: 800-241-1848 • F: 804-262-6277 • www.babyjogger.com