Transcript
SAFE WORK PROCEDURE
Grablab Darkroom Timer 450 Page 1 of 2
LOCATION Schools in PTSD
WRITTEN BY: APPROVED BY: Lorie Carriere Allen Zadorozny
School Principal
DATE CREATED December 31, 2015
LAST REVISION New
PERSONAL PROTECTION EQUIPMENT (PPE) Appropriate footwear must be worn. Shoe must be fully enclosed. No open toed shoes.
Long and loose hair must be tied back. Rings and jewelry (long necklaces / bracelets, etc.) must not be worn. Safety glasses or goggles must be worn at all times in work areas.
Close fitting/protective clothing must be worn. Remove strings hanging from pullovers/sweaters.
HAZARDS PRESENT Pinch points Burns Fire
ADDITIONAL REQUIREMENTS
Equipment orientation Read & understand general safety procedures Instructor supervision is require Use tools only for their intended purpose Never store/use chemicals near machine for risk of fire/explosion hazard.
SAFE WORK PROCEDURE DO NOT use this equipment unless a teacher has: instructed you in its safe use and operation; permission has been given; and supervision is present
SAFE WORK PROCEDURE
Grablab Darkroom Timer 450 Page 2 of 2
MODEL 450 UNSWITCHED TIMER OPERATION PROCEDURE: 1. 2. 3. 4. 5. 6. 7.
Turn the timer on by switching the ON/OFF switch to the ON position (#9). Set the display intensity level using the display intensity control (#7). Set the time range using the time range control (#2). Set the time using the time entry control dials (#3). Select the Audio to OFF, METRO or TONE (#4). Set the outlet control to TIME (#6). Press the START/RESET bar. Pushing this bar during a cycle stops the timer and automatically resets it to the originally set time.
MODEL 450 SINGLE –CYCLE SWITCHING OPERATION PROCEDURE: 1. 2. 3. 4. 5. 6. 7. 8.
Plug the control device into the timer AC outlet. Set the display intensity level using the display intensity controls (#7). Set the time range using the time range control (#2). Set the time using the time entry control dials (#3). Select the Audio to OFF, METRO or TONE (#4). Set the outlet control to TIME (#6). Press the START/RESET bar. To adjust the controlled device prior to the timing operation: a) Set the outlet control to “FOCUS”. b)Make adjustments and then reset the outlet control to “TIME” (#6).
If an emergency situation occurs while conducting this task or there is an equipment malfunction, shut the equipment off immediately. REPORT ANY HAZARDOUS SITUATIONS TO YOUR SUPERVISOR IMMEDIATELY.
REGULATORY REQUIREMENTS
MB. Regulations 217/2006, Part 2, Section 2.1 Safe Work Procedures Part 6, Section 6.1 PPE Part 16, Sections 16.1 – 16.18, Machine & Tool Safety WS&H Act W210, Section 4, 5, 7, 7.1 Operators Manual
