Ha72170-nf Installation Guide 1.operational Overview 2. Step By Step Installation Www.l-com.com

Transcript

www.L-com.com HA72170-NF Installation Guide 1.Operational overview 2. Step by step installation Step 1: Mount the outside antenna (sold separately) a. Choose right position • Find the strongest signal position in the possible in stall locations by read your cell phone signal bar; • 30cm (1.0ft) away from any other metallic objects; • 100cm (3.3ft) away from any windows; Step 1: The powerful outside antenna captures voice and data signal and transfers it to the booster; Step 2: The booster receives the signal, amplifies it and rebroadcasts it by inside mounted antenna. Step 3: Your mobile devices get a better signal, never experience dropped calls or slow data speed. b. Securely mount the outside antenna using hardware supplied with antenna or one of the available mounts available from L-com. c. • • Connect outside cable to the antenna Make sure connectors are securely fastened Seal the connectors with weatherproof tape Supported Carriers • • • • • • • • AT&T 2G/3G/4G (HSPA+ & LTE) Verizon 3G/4G T-Mobile 2G/3G/4G Sprint 3G/4G US Cellular 3G/4G Metro PCS 3G/4G Major Canadian Carriers 2G/3G/4G All other carriers using 700MHz, 750MHz, 850MHz and 1900 MHz Coverage Area Note: The ability of coverage depends on output power of booster. Any boost has a limit of amplification factor, so final output power is related to received signal power level at the outdoor mounted antenna. Power level at outdoor mounted antenna location Coverage Area (sq. ft.) Strong (5 bars on the cellphone) 12000 Medium (3~4 bars on the cellphone) 8000 Weak (1~2 bars on the cellphone) 800 IP-00136 Rev A 02/19/16 © L-com, Inc. All rights reserved. L-com Global Connectivity and the L-com logo are registered marks. www.L-com.com e. • • Run the outside antenna cable into the building Carefully arrange the cable along the building outside making sure are no sharp bends; Fix the cable at each corner; Step 3: arrange the booster a. Choose position • Be sure to mount away from any heat source; • In a ventilated dry place, temperature range should -5° to +50° C (23° to 122° F); b. c. Connect the outside antenna’s connector to the “outside” labeled port of the booster; Connect the inside antenna’s connector to the “inside” labeled port of the booster; Inside antenna Outside antenna Step 2: mount the inside antenna (sold separately) a. Choose right position • 20cm (0.6ft) away from any other metallic objects; • 50cm (1.6ft) away from any windows; • For the panel type antennas, position at the end of the building is recommended; b. Mount the inside antenna; c. Connect the inside cable to the inside antenna; Adapter cord Step 4: power on the booster a. Plug the power adapter to the AC power; b. Attach the cord of the adapter to the booster; For HA72170-NF operational manual, please visit www.L-com.com IP-00136 Rev A 02/19/16 © L-com, Inc. All rights reserved. L-com Global Connectivity and the L-com logo are registered marks.