Transcript
OPERATING INSTRUCTIONS
Your added A/V source can now be viewed via the AV button, the audio will switch as factory. The added source can be in PAL or NTSC format, the unit will now auto switch between these.
OPV-2C A/V INPUT & VIDEO INMOTION PORSCHE CAYENNE 2004 on With TV Tuner NAV TV (UK) LTD
NAV TV (UK) LTD Unit R4 Capital Business Park Wentloog Cardiff CF3 2PU Telephone: + 44 (0)870 801 0440 Fax telephone: + 44 (0)870 801 0441
[email protected] Disclaimer NAV TV (UK) Ltd is not liable for any incidental, consequential or indirect damages. In case of erratic behavior of the vehicle’s electrical system please disconnect the NAV TV product and contact our technical support Team. NAV TV (UK) Ltd does not assume liability for any diagnostic fees.
e11*72/245*2004/104*4020*00 RoHS 2002/95/EC—2002/96/EC
LOCATION & REMOVAL Installation is made at the front unit.
INSTALLATION Installation for OPV-2C (CAN) Connect at mini ISO & ISO as follows:
To remove the head unit you will need to remove the surrounding trim then the 4 screws securing the unit
INSTALLATION Insert OPTICAL leads into OPV-2C loom and car loom to create loop, see diagram below
Remove the Mini ISO & ISO power plug from the rear of the radio and plug them into the female side of the supplied harness. Then plug in the male side of the supplied harness into the radio. Connect this lead to the OPV-1C (CAN) interface.
IN cable from interface
OUT cable from screen
INTERFACE
Installation for OPV-2C (MOST) Connect the factory plug from the GREEN socket of the unit to the supplied harness, and plug female plug from supplied harness to the GREEN socket on the rear of the unit, see below.
CAR CONNECTOR
To remove the (out) fibre optic cable from the factory connector you will need to remove the black outer casing and push out the blue locking insert. You will need to do the same to insert the cable into the supplied loom. (shown in previous fig) Other Connections Connect the RED cable to 12v+ PERM Connect the BLACK cable to 12v- GROUND Connect the BLUE cable to12v+ to activate AUX IN Connect the cable AUDIO sockets on the OPV-2C to your audio source Plug in and mount the interface
With the interface fitted the information cluster will be disabled, to re-activate the information cluster you may add a manual switch to the purple cable (pin5) of the supplied Navtv harness to switch off the AV input feature whilst using other applications.
