Transcript
HDE35-AL-SP 3.5 inch Portable Enclosure User Guide (Support Windows OS and MAC OS) Packing Detail
3.5 inch Portable Enclosure
USB3.0 cable
Quick Start guide
Installation instruction step 1.
USB 3.0 A USB3.0(
USB2.0
,
/
USB2.0)
For the first time using this product, please connect the USB 3.0 A type or USB 2.0 male type cable to the interface USB 3.0 or USB 2.0 on Desktop or Notebook.
2.
USB3.0 B(
)
3.5
USB3.0 B
Then, connect the USB 3.0 B (male type cable) to the interface USB 3.0 B on the 3.5 inch Portable Enclosure device for charging.
3.
LED (
:
USB2.0 A(
1
20~30 2
)
USB 3.0 A( /
)
)
Please charge battery for at least 20-30 minutes after the yellow LED is lit up. (Note: If step 1 and step 2 are swapped, please finish inserting two USB ports in 3 seconds, which connects the USB 3.0 A type or USB 2.0 male type cable to the interface USB 3.0 or USB 2.0 on Desktop or Notebook.)
4. (
:
LED
)
The driver will install automatically, then the product can be used.
Battery will be
charged back slowly when using the enclosure. (Note: When the hard disk is on the process of start-up, it is normal working phenomenon of the yellow LED going off temporarily)
5.
LED The flashing Blue LED indicates that the hard disk is reading or writing
6.
LED
,
3
If the yellow LED goes off, it indicates low power, please repeat step 3.
Note:
6 1. If the product is not used for a long time, more than six months or more, the hard drive does not start normally occurring phenomenon, indicated the power is low. Please repeat the step 6.
PC
USB
PC
USB
2. This product is suitable for notebook and PC motherboard’s USB port. It might be power shortage when using USB interfaces on PC front panel or USB hub.
USB3.0
USB
3. Please use the product-specific of USB3.0 cable. No third party USB cable used.
4. Do not open the housing by your own behaviour, otherwise will lose the warranty coverage.
