Transcript
Do not use on people who are asleep. Never drop or insert any object into any opening of this styler. Do not use outdoors or where aerosol (spray) products are being used or where oxygen is being administered. The barrel will be very hot during use. Do not let bare skin touch heated surface. Do not place the heated styler on any soft surface such as a bed, carpet or a towel. Place only on a hard, flat, heat resistant surface.
To reduce the risk of death by electric shock:
•
Always unplug the appliance immediately after using. Do not place or store an appliance where it can fall or be pulled into a bath or sink. • Do not use while bathing. • Do not place or drop into water or other liquid. • If an appliance falls into water, “unplug it” immediately. Do not reach into the water. Remington strongly recommends that an approved Safety Switch (residual current device) should protect all bathroom power outlets. Ask an electrical contractor for advice.
•
WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION AND FIRE OR INJURY TO PERSONS.
MAINTENANCE
• •
• •
•
•
•
Your styler should never be left unattended when plugged in
to a power outlet. Keep this product out of reach of children. The use of this appliance by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge can give cause to hazards. Persons responsible for their safety should give explicit instructions or supervise the use of the appliance. Use this styler only for its intended use as described in this manual. Do not use attachments not recommended by Remington. Never operate this styler if it has a damaged cord or plug, if it is not working correctly, if it has been dropped or damaged or dropped into water. If the supply cord or plug of this styler is damaged it must only be replaced by a qualified electrical tradesperson. Keep the power cord away from heated surfaces.
• • •
SAVE THESE INSTRUCTIONS
This product is not suitable for use in the bath or shower. This product conforms to radio frequency interference requirements.
HOT STYLER
Warranty information can be found in the enclosed warranty card.
USE & CARE INSTRUCTION MANUAL
Any product purchased and used commercially carries a limited 90 Day Warranty.
PLEASE READ PRIOR TO USE
This styler is designed for household use and is virtually maintenance free. If cleaning becomes necessary, disconnect the styler from the power outlet, allow it to cool, and then wipe the exterior surface with a soft damp cloth. Do not immerse the unit in any liquid.
STORAGE When not in use, always unplug the styler from the power outlet. Allow the styler to cool and store out of the reach of children in a safe dry place. Ensure that you empty the water reservoir before storing your styler. Never wrap the power cord around the styler as this will cause the cord to wear prematurely and break. Handle the cord carefully for long life and avoid jerking, twisting or straining especially at the power plug and styler connections. If the cord becomes twisted in use, periodically straighten it.
REMINGTON SERVICE HOT LINE Australia 1800 623 118 (toll free) New Zealand 0800 736 776 (toll free) www.remington-products.com.au Remington Products Australia Pty Ltd Chifley Business Park 1 Chifley Drive, Mentone, Victoria, 3194, Australia
Remington Products New Zealand Ltd Building C, Ground Floor 600 Great South Road, Greenlane, Auckland, 1051, New Zealand
®Registered Trade Mark of Spectrum Brands, Inc., or one of its subsidiaries. ©2010 SBI Rev: 04/10 Part No. T22-30053
2 YEAR WARRANTY
STYLES AND CURLS
CB4N
CB4N HOT STYLER Use & Care Instruction Manual Thank you for purchasing your Remington® Hot Styler. The Hot Styler creates volume, curls and waves. It includes a refillable, easy to use water tank which produces steam through the brush for long lasting styling results. The Hot Styler also comes with 2 sets of heat resistant bristles to help create the latest hair looks.
BASIC HAIR CARE INSTRUCTIONS For optimal results, shampoo and condition your hair prior to styling. Dry your hair thoroughly before using the Hot Styler and make sure that it is tangle free. The Hot Styler is not suitable for use on synthetic wigs or hair extensions.
AUTOMATIC VOLTAGE ADJUSTMENT The Hot Styler features automatic voltage adjustment for international use. Plug the unit into any domestic power outlet and it will adjust automatically to the voltage being supplied.
KEY PARTS
Note: - Some countries will require the use of a plug adaptor that is not included with your styler. ON LED indicator light
Salon swivel cord
Curl release button
STEAM FUNCTION A
Water reservoir
Ceramic coated barrel 2 sets of heat resistant bristles – 10mm and 6mm
The Hot Styler can be used with or without steam. Steam will help to set a longer lasting style. When steam is required, first fill the water reservoir. Hold the unit in a vertical position with the cord positioned at the top and unscrew the water reservoir. (Diagram A) Ensure that the bristle lock guard remains securely on the unit. Fill the water reservoir with warm or cold water. Hold the unit in a vertical position again, with the cord positioned at the top. Tightly screw the water reservoir back on. Do not pour water into the barrel as this will cause it to drip.
HOW TO CHANGE THE HEAT RESISTANT BRISTLES B
HOW TO USE YOUR REMINGTON® HOT STYLER Place the styler on a flat, hard, heat resistant surface. Plug in to any household (120/240V AC) power outlet. The LED indicator light will illuminate indicating that the styler is on.
• • • • • • •
Worldwide voltage
Bristle lock guard
To activate the steam gently depress the water reservoir. The depressing of the water reservoir will release enough steam required for one small section of hair.
Ensure that your hair is completely dry. To make styling easier, part your hair either in the middle or to the side and use clips to section your hair, top, sides and back. You may need to comb through your hair before styling to ensure that it is tangle free. Take about a 5cm section of hair and pull taut, down and away from the scalp. Holding the styler, wrap your hair around the hot barrel and wind up. If steam is required depress the water reservoir. Hold the Hot Styler in place for 8-12 seconds. To remove, press the curl release button and carefully draw the hot styler away, allowing your hair to unwind automatically. Allow the curl to spring back and cool before combing. Alternatively you can use the Hot Styler to add volume to the roots, by placing it under a section of hair close to the roots and holding it in place for 8-12 seconds.
To switch your styler off, unplug from the power outlet.
The Hot Styler comes with two complete sets of heat resistant bristles. The longer bristles (10mm) are generally better to grasp shoulder length or longer hair and will add volume or create lose curls. The shorter bristles (6mm) are designed for shorter hair and are ideal for curls and soft styling. Ensure that the styler is unplugged and cool. Unscrew the bristle lock guard and slide the bristles off the barrel (Diagram B). Take the other set of bristles and gently glide each row of bristles into the groove on the barrel and push into place. Screw the bristle lock guard securely back into place.
IMPORTANT SAFEGUARDS Warning: Do not use this appliance near bath tubs, showers, basins or other vessels containing water. When using electrical appliances, especially when children are present, basic safety precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING KEEP AWAY FROM WATER DANGER – As with most electrical appliances, electrical parts are electrically live even when the switch is off.
