How To Solar Charge The Hybridlight™ Solar

Transcript

HYBRIDLIGHT™ is a unique state-of-the-art solar technology at its best. * For best results: Charge the Flashlight using a Micro USB cable until the indicator light turns GREEN Power In (Micro USB) HOW IT WORKS: • 1st Click = Low Beam Power out (Standard USB) • 2nd Click = High Beam • 3rd Click – “Off” position. How to charge the HybridLight™ Solar Flashlight using a Micro USB cable: 1. Be certain the Flashlight is in the “off” position. 2. Remove the bottom cap counter-clockwise. 3. Plug the Micro USB cable into the power in charging port. Plug the other end of the cable into an A/C or D/C power source. 4. The indicator light on the Flashlight will be RED while charging. 5. The indicator light on the Flashlight will be GREEN when fully charged. How to charge a cell phone using a charging cable: 1. Remove the bottom cap counter-clockwise. 2. Plug the cable into the Standard USB power out charging outlet located on the bottom of Flashlight. 3. Plug the other end of the cable into cell phone. 4. Replace bottom cap when not charging device. How to solar charge the HybridLight™ Solar Flashlight 1. Be certain the Flashlight is in the “off” position. 2. Place Flashlight under natural sunlight with the solar panel facing the sunlight. Ambient light source will also charge flashlight. The brighter the light source the faster Flashlight will recharge. 3. The RED charging indicator light will illuminate if the light source is bright enough to recharge the solar panel. If the charging indicator light is not illuminated, place Flashlight in a location with a brighter light source. Troubleshooting Flashlight does not charge the cell phone: The Flashlight power is too low to charge the cell phone. Rapid charge the flashlight using a Micro USB cable. The Flashlight should stay plugged in until indicator light turns GREEN. The Flashlight is now ready to charge a cell phone. Flashlight does not turn on even though it has been charged: You may have charged the Flashlight in the “on” position. The Flashlight must be charged in the “off” position. Flashlight is dimming: A dim light indicates you need to recharge the Flashlight. The RED indicator light will also flash when it needs to be recharged. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. ************************************************************************************************************** *************************************************** Notes: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help.