Transcript
HRKS Adhesive Backed Antenna Mount General Specifications
Adhesive backed for easy mounting UHF Mounting base, adjustable position Black Finish Power Rating: 350 Watts Coaxial Cable: 13.5” RG316 Teflon cable with SMA connector and PL259 adapter.
RECOMMENDED ANTENNAS: NR770HA or NR770HB
INSTALLATION INSTRUCTIONS 1. Choose desired mounting location on vehicle to ensure maximum strength of mount and best performance of antenna. Location must be a flat surface preferably window, roof, or trunk lid. Avoid obstructions such as window defrosters, hatches, or air spoilers. Figure A.
2. When desired location is determined, surface must be cleaned thoroughly to ensure proper adhesion to mounting surface. Figure B.
Clean surface thoroughly
3. Mount must be attached with longer surface pointed to front of vehicle (Roof or Trunk mounting) or vertical (Window mounting) Figure C. WARNING: IF MOUNTED TO VEHICLE PAINT, IT COULD REMOVE OR DISCOLOR PAINT. CHOOSE MOUNTING LOCATION CAREFULLY. DIAMOND ANTENNA IS NOT RESPONSIBLE FOR ANY VEHICLE DAMAGED BY MOUNTING TO VEHICLE PAINT. Figure C
Roof or Trunk mounting
Figure A
Figure B
1.5”
4”
Window defrosters Window mounting
Hatches or spoilers
4. Route coaxial cable from antenna mount to radio.
Curved surfaces
5. Attach connector to radio. If radio has UHF connector, assemble PL-259 adapter to cable end and attach to radio.
REMOVING MOUNT
Figure D
If it becomes necessary to remove HRK mount from vehicle, we suggest using heavy gauge fishing line to remove seal from surface of mount and vehicle. Figure D. ( NOTE: Contact Diamond Antenna customer service for reattachment kit)
PARTS LIST
Mount Attachment 0210101
HRKS
Mount Plate 0210102
Mount Structure 0210108
Hex Nuts 0210109
Spring 0210104 Washer 0210105
Adhesive Sheet 0210103
Mount Plate
Adhesive Sheet
Adjustment Knob 0210105
DIAMOND ANTENNAS are distributed by R.F. Parts Co. San Marcos, Ca (760) 744-0900
Hex Wrench 0210107
