Preview only show first 10 pages with watermark. For full document please download

Hs--mod001 Brkt_im_eng_29034473

   EMBED

Share

Transcript

HS-MOD001-Brkt Bracket for HS-VM1100 Modulator INSTALLATION INSTRUCTIONS Introduction The HS-MOD001-BRKT supports the HS-VM1100 modulator for installation in a Concourse cabinet. This bracket comes complete with the small mounting plate required to complete the installation. Before installing the module, confirm that the package contains the following parts: one bracket, one mounting plate, one 5/16" hex nut and four plastic standoffs. Installation Instructions 1. 2. 3. 4. 5. 6. Set the HS-VM1100 onto the bracket and slide the “F” connector through the hole in the tab and secure with the hex nut. Insert the standoffs into the mounting plate as per Figure 1, matching the hole pattern on the bracket. Select a suitable mounting location for the assembled bracket inside the cabinet. A location near the splitter/combiner (e.g., HS-VH400) is recommended. Align the two mounting tabs with the slots in the wire raceway and insert. Snap the module into place by pushing the opposite side towards the back of the cabinet. Connect the HS-VM1100 as per the Installation Instructions provided with the unit. DSC Home Systems is a division of Digital Security Controls Ltd. 2001 Digital Security Controls Ltd.•Toronto, Canada 1-800-387-3630 • www.dsc.com Printed in Canada 29034473 R001 HS-MOD001-Brkt Bracket for HS-VM1100 Modulator INSTALLATION INSTRUCTIONS Introduction The HS-MOD001-BRKT supports the HS-VM1100 modulator for installation in a Concourse cabinet. This bracket comes complete with the small mounting plate required to complete the installation. Before installing the module, confirm that the package contains the following parts: one bracket, one mounting plate, one 5/16" hex nut and four plastic standoffs. Installation Instructions 1. 2. 3. 4. 5. 6. Set the HS-VM1100 onto the bracket and slide the “F” connector through the hole in the tab and secure with the hex nut. Insert the standoffs into the mounting plate as per Figure 1, matching the hole pattern on the bracket. Select a suitable mounting location for the assembled bracket inside the cabinet. A location near the splitter/combiner (e.g., HS-VH400) is recommended. Align the two mounting tabs with the slots in the wire raceway and insert. Snap the module into place by pushing the opposite side towards the back of the cabinet. Connect the HS-VM1100 as per the Installation Instructions provided with the unit. DSC Home Systems is a division of Digital Security Controls Ltd. 2001 Digital Security Controls Ltd.•Toronto, Canada 1-800-387-3630 • www.dsc.com Printed in Canada 29034473 R001