Transcript
P /N 9 5 - 0 7 5 5
IFS INTEGRITY FENCE SYSTEM - FENCE ONLY INSTRUCTIONS
ABOVE GROUND POOL SAFETY WARNING
FAILURE TO HEED THESE WARNINGS CAN RESULT IN PERMANENT INJURY, PARALYSIS FROM A BROKEN NECK, ELECTROCUTION OR DROWNING.
THIS POOL IS NOT DESIGNED FOR DIVING OR JUMPING! DANGEROUS INJURY CAN RESULT, SHALLOW WATER!
Your pool contains a large quantity of water, and is deep enough to present inherent dangers to life and health unless the following safety rules are strictly observed. First-time users run the highest risk of injury. Make sure everyone understands. To insure your pool is used safely you must observe the following safety precautions: 1. NO JUMPING OR DIVING
9. KEEP OFF TOP LEDGES
The top rail of your pool is not a walkway and must not be used for jumping or diving. Do not permit jumping or diving into the pool from a deck or the top rail of the pool. Diving or jumping into the pool can result in serious injury.
10. POOL COVER SAFETY
Do not walk on top ledges. They can be slippery and they are not a walkway.
2. NEVER USE THE POOL ALONE
The cover must have a tamperproof locking retainer cable that positions the cover around the pool wall and keeps it securely in place. Never allow anyone, especially small children on the cover. Asphyxiation or drowning could result. When purchasing any pool cover, please consult a swimming pool professional.
3. NEVER LEAVE CHILDREN UNATTENDED
11. ELECTRICAL HAZARD
Never permit the pool to be used unless it is attended by at least one person other than the bather. Someone should always be available to lend assistance in an emergency. Never leave a child alone and unsupervised in or near the pool—not even for a second. There is no substitute for constant adult supervision.
4. NO ROUGH PLAY
Do not permit “rough-playin” in and around your pool. Surfaces can become slippery and hazardous when wet.
5. LIGHT THE POOL AT NIGHT
If the pool is used after dusk, adequate lighting must be provided. Illumination in the pool area must be sufficient to clearly judge pool depth and all features in and around the pool. For lighting recommendations, consult your local licensed electrical contractor
6. RESTRICT ACCESS TO THE POOL
Do not leave chairs or other furniture beside the pool that could be used by a child to climb up into the pool. Ladders must be removed whenever the pool is unattended. A fence with a lockable gate around the pool or yard is strongly recommended and may be required by law in some jurisdictions.
7. NO ALCOHOL OR DRUGS
Never drink alcoholic beverages or use any intoxicants which could hinder your judgment and reflexes.
8. KEEP YOUR POOL CLEAN AND SANITARY
Your filter system will remove suspended particles from the water and the surface skimmer will remove insects, leaves and other debris from the water surface. Use the correct pool chemicals as directed to destroy harmful bacteria and prevent formation of algae. Remember, unsanitary water is a serious health hazard.
Never touch or attempt to service electrical equipment, including the filter when your body and/ or the ground is wet. Electrocution or permanent injury due to high voltage (120V AC) could result. The pool should be bonded in accordance with Section 680-26 of the National Electical Code. For further assistance contact your dealer or a local licensed electrician. Do not use pool during electrical or rain storms.
12. SAFETY ROPE & POLE
Keep a safety rope 1/4" by 50" with a flotation buoy with an outside diamter of 15". Have accessible in a prominent area by your pool. Keep a pole not less that 16 feet (4,88m) long with a blunt or hook end available at pool side in case of emergencies.
13. POOL CHEMICALS
Do not place chlorine, chlorine tablets or sticks directly into skimmer, or winterize your pool with liquid chlorine. Damage to the skimmer, pool liner and filter will result. Failure to obey this instruction will void all component warranties. Always follow Chemical Manufacturer’s insturctions when storing, handling and dispensing pool chemicals.
14. CHECK FOR DAMAGE
Periodically check your pool and ladder components for damage and wear. Be sure all screws are in place. Replace all damaged or worn components and tighten all screws before you use the pool, deck or ladders. At first sign remove rust and touch up immediately.
15. POOL PARTS
Never modify the pool or accessories, or remove or drill holes in the pool, deck or ladder components unless instructed. Your pool wall is made of thin metal, there is an inherent cut hazard with metal so use gloves during installation. Always use Original Equipment Manufactured parts for your replacement parts.
FOLLOW ALL SAFETY INSTRUCTIONS Read and follow all safety instructions packaged with pool, ladder, deck or any other accessory. Additional pool safety publications can be obtained by contacting: The Association of Pool & Spa Professionals (www.apsp.org)
REMEMBER WATCH CHILDREN
IMPORTANT NOTICE READ BEFORE INSTALLATION!
The safety stickers must be installed as per following instructions. Failure to properly install warning labels will void warranty. Failure to mount these safety labels may subject you to substantial liability in case of injury. These warning are not to be removed under any circumstances! If they become discolored or fall off please request replacements which will be sent at no charge. PLACE SIGN ON LINER ABOVE WATER
PLACE SIGN ON
LINE, OPPOSITE ENTRY
WALL NEXT TO
TO POOL
POOL ENTRY
R.12/11
INTEGRITY FENCE SYSTEM INTRODUCTION: The Integrity Fence System is designed to work on above ground swimming pools. In order for the IFS (Integrity Fence System) to work on your pool, the proper kit needs to be ordered and installed. The following considerations should be taken into account when ordering and installing your IFS. · · · ·
Does the pool have a metal or resin upright? As per the following instruction, each type of upright requires its own post holder. Please make sure that you have the correct post holder for your style of pool upright or the fence will not be installed securely. What model pool is the fence going onto? Each brand of pool has different spacing between the pool uprights, requiring different fence section lengths. Your kit needs to come with the correct length parts for your pool. How many uprights are on the pool? The number of fence sections supplied needs to match to your pool. Are you installing fence only on your pool or fence and deck? The number of sections and the length of fence section changes if you are installing a deck onto your pool.
Please follow the step by step instructions to properly install and secure your IFS. If you are missing any parts or have any questions please contact the dealer where you purchased your fence system. It is important that the owner of the pool determines if the fence being installed meets all local codes. The owner is responsible for finding out if the fence meets all local codes. Every state, town, village, municipality may have its own codes that the pool owner has to comply with. STEP 1: INSTALL THE POST HOLDER ONTO THE UPRIGHTS See the exploded assembly view below. The holes for attaching the Post Holder to the Upright must be measured and drilled as PER the instructions show. The post holder must be attached to the pool Upright before the upright is installed on the pool. After the pool is installed then you can go back and install the Fence Post and the Fence Sections. THIS STEP MUST BE DONE BEFORE THE UPRIGHTS ARE INSTALLED ON THE POOL Resin Upright
Steel Upright Upright
9-7/8" *
5/8" typ.
Installed before upright is put onto pool. 1/4-20 Machine Screws 3/4" long
Two holes drilled (0.281" Dia) to install the Fence Post Holder. Must be done by Fence installer.
3-3/4"
0.281" Dia holes drilled by Fence installer. Two on each side. Four Total.
1/4-20 3/4" long Machine Screws
9-3/4" *
3.0" Post Holder Installed before upright is put onto pool.
* Important dimension so the Fence is at the correct height
Holes must be centered on Upright
STEP 2: INSTALL THE POST INTO THE POST HOLDER Your above ground swimming pool should now be installed. All the post holders were attached to the pool uprights before the pool was installed. Please go around the pool and install your fence posts onto each of the post holders. Resin Upright
Steel Upright
Fence Clips
Fence Post
Machine Screws 1/4-20 x 2" Machine Screws 1/420 x 2"
Note: To ease installation of the Fence Clips on step 3, we suggest installing them before attaching the Posts to the Post Holders. STEP 3: INSTALL THE FENCE CLIPS INTO THE FENCE POSTS On each fence post install the Fence Clips. Note that the direction of the hook on the Fence Clip must face as shown in the image.
Note the direction of the hook on the Fence Clip
Fence Post Holder
Fence Post
STEP 4: PLACE THE FENCE SECTION INTO THE FENCE CLIP Place the fence section into the Fence Clips between the posts. It is extremely important that you place the correct length fence section into the correct location on your pool. See the diagrams at the end of the instructions so you know which fence section to place at which location on your pool. · Slide the fence section into a pair of the Fence Clips on one post · Adjust the Fence Clips out, away from the pool, and gently slide the fence section into the other set of Fence Clips. · Do not attach the Fence Section to the Fence Clips! · Go around the pool and install all the Fence Sections. · Center each fence section. Make sure that the space between each Fence Section and the Post is less than 4”. Make sure that the space between the pool and the fence is less than 4”. Fence Section
Fence Clip
Fence Post
Install the Fence Section into the first set of Fence Clips
Adjust the Fence Clip out away from the pool and slide the Fence Section into the Fence Clip
STEP 5: INSTALLATION OF OTHER FENCE SECTIONS Repeat step 4 until all the fence sections are installed.
NOTE: The top of the Fence Panel has a screw cover over it. Make sure to install the Fence Panel the right way.
STEP 6: ATTACH THE FENCE SECTION TO THE FENCE CLIPS Double check that your fence sections are centered between the fence posts. Attach the Fence Sections to the Fence Clips. · The screws that you will use to attach the Fence Sections to the Fence Clip are self taping. This means that you can drill them directly into the aluminum. You do not need to pre-drill a starter hole · The screws are painted Taupe, the same color as the rest of the fence · Each Fence Clip has a hole on the outside and the inside of the pool. Attach each Fence Clip to the Fence Section with 2 of the screws. You will need a ladder to install the screws that attach the top Fence Clips to the Fence Section. Install the Resin Fence Caps onto the fence posts as you work your way around the pool. Resin Post Caps Self taping screws on both sides
Self taping screws on both sides
Finished Fence installed on a Pool with Deck
INTEGRITY FENCE SYSTEM PARTS LIST PART NUMBER DESCRIPTION 11513
POST HOLDER TAUPE (METAL UPRIGHT)
29751
ATM POST HOLDER TAUPE (RESIN UPRIGHT)
IFS-10122
IFS FENCE POST TAUPE 50 5/16"
IFS-10001
IFS FENCE CLIP ADJUSTABLE 6-3/4" TAUPE (3634)
99-0023
MACHINE SCREW 1/4-20 X 3/4" 18-8 SS PHIL TRUSS
99-0016
MACHINE SCREW 1/4-20 X 2" 18-8 SS PHIL TRUSS
99-0017
NUT 1/4-20 18-8 SS SERRATED FLANGE
99-0118
SCREW #8X1/2 PHIL PAN TEK PTD TAUPE
11498
FENCE POST CAP SINGLE TAUPE IFS FENCE PANEL IDENTIFICATION CHART MINIMUM MAXIMUM OPENING WITH OPENING WITH NUMBER OF BRACKETS ON THE BRACKETS ON THE PICKETS ON PANEL ENDS OF THE PANEL ENDS OF THE PANEL
PART NUMBER
LENGTH OF PANEL WITH NO BRACKETS
IFS-10111
7-7/16"
11-1/4"
15-1/4"
2
IFS-10112
12-3/4"
15-1/16"
20-1/4"
3
IFS-10113
18-1/16"
20-5/16"
25-1/2"
4
IFS-10114
23-3/8"
25-5/8"
30-7/8"
5
IFS-10115
28-5/8"
30-15/16"
36-1/4"
6
IFS-10116
34"
36-5/16"
41-1/2"
7
IFS-10117
39-5/16"
41-9/16"
46-13/16"
8
IFS-10118
44-5/8"
46-7/8"
52-1/8"
9
IFS-10119
49-15/16"
52-3/16"
57-7/16"
10
IFS-10120
55-1/4"
57-1/2"
62-3/4"
11
