Transcript
IKELITE DUAL CORD #410 3.52
The blue band identifies this TTL/Digital cord as digital-compatible. Connect TWO Ikelite TTL/Digital Substrobes to one Ikelite TTL/Digital housing. Different model TTL/Digital Substrobes can be combined as dictated by the housing and its compatible strobe limitations. The strobes can be fired in TTL/auto and manual exposure modes, provided the housing features the appropriate TTL/auto hot-shoe assembly. Otherwise the strobe triggering thru the cord is limited to manual exposure only. Use both strobes in the same exposure mode, TTL/auto or manual. Please refer to your housing instruction manual or the Ikelite internet web site for additional compatibility information. Primary Substrobe IKELITE Style Connector
Blue Band Red Band Secondary Substrobe
ONLY IKELITE TTL/Digital SUBSTROBES CAN BE CONNECTED. DO NOT use the TTL cord on a non-TTL strobe; you will damage the camera
CONNECT THE CORD___________________________________________ 1. 2. 3. 4. 5.
Connect housing to the cord end with the blue band. Connect secondary strobe to the cord with the red band. Make sure all components are dry. Clean and lightly lubricate the stem o-rings and both the strobe and housing connector threads. Check the o-ring for nicks or cuts. Note the positioning of the receptacles and pins. Properly align the end of the sync cord and insert into the strobe and housing connectors. Hand-tighten the knurled ring on the sync cord. Push the connector body further into the connector and continue to tighten the knurled ring.
Stem O-ring Retaining Ring
Blue Band
DO NOT remove the sync cord from the strobe or camera underwater or when wet. Connections are NOT waterproof when disconnected underwater. DO NOT leave the cord connected for prolonged periods. Otherwise, the cord may freeze to the strobe or camera. After each dive, disconnect the cord and lightly lubricate the connector threads. Never use spray lubricant.
FIRING ONLY ONE STROBE_____________________________________
Both strobes must remain connected at all times underwater. Connect your secondary strobe to the cord with the red band. Should you decide to use only one Substrobe, turn OFF the strobe connected to the cord with the red band. If you turn OFF the other strobe, the ready light in the camera viewfinder will NOT light, the camera's shutter speed may not sync with the flash, and the TTL automation is cancelled.
LIMITED WARRANTY___________________________________________
All Ikelite products are warranted against any manufacturing defects for a period of one (1) year from the date of purchase. Defective products should be returned prepaid to Ikelite. Ikelite will, at its discretion, repair or replace such products, and will return to customer prepaid. All other claims, of any nature, including but not limited to bulb failure are not covered. Except as mentioned above, no other warranty expressed or implied, applies to this Ikelite product. IKELITE UNDERWATER SYSTEMS 50 West 33rd Street, Indianapolis, IN 46208 USA (317) 923-4523 4103.52-01-1106
