Im-uk Gebruiksrichtlijn Drukvat Spuitsysteem

Transcript

Hertalan Installation Manual User guideline hertalan ks205 pressurised canister spray system Introduction The hertalan ks205 pressurised canister spray system is a ready for use contact adhesive spray system. In conjunction with a hose and spray gun the adhesive can be sprayed directly without necessity of a compressor or power supply. For correct and safe working with the hertalan ks205 pressurised canister spray system please read this guideline carefully. Before use − Read the Technical Note and the Material Safety Data Sheet of hertalan ks205 pressurised canister spray system. − Be certain that all components of the spray system, canister, hose and spray gun, are free of damage and have no defects. Connecting hose and spray gun − Connect the spray gun to the hose. Be sure that the coupling nut is tightened correctly and firm, so there can be no leakage of adhesive. − Completely close the control knob of the spray gun. − Connect the hose to the valve of the canister. Be sure that the coupling nut is correctly fitted to prevent leakage of adhesive. − Open the valve of the canister slowly, but completely and check for any leakage. Product usage Directly before use, shake or roll the canister for at least 30 seconds for homogenizing the content to achieve a regularly spray pattern. − Using the control knob of the spray gun, adjust the supply of adhesive and spray pattern as desired. − After use, completely close the control knob of the spray gun. The valve on the canister should stay open until the canister is empty and/or has to been replaced. − After spraying, leave any adhesive residue at the nozzle to dry. Remove this before the next use of the spray system. Don’t use sharp objects! − The nozzle can be cleaned with acetone or white spirit. − Warning Never fully unscrew the control knob of the spray gun (standard), it has no end-lock and the adhesive then will escape uncontrollably. Exchange of canister − Empty the canister and hose until there is no adhesive (only propellant) coming out. − Close the valve on the canister completely. − Disconnect the hose from the canister, keep the spray gun open (be aware of adhesive residues coming out) so there will be no pressure build up in the hose. − Close the control knob of the spray gun completely as soon as the hose is disconnected from the canister. − Connect the hose with spray gun immediately onto a new canister and open the valve of the canister slowly and completely. Disposal of empty canister − Open the valve of the old canister to release any remaining pressure. Be aware that adhesive residue can come out. Do this preferably outside or in a well ventilated space. − Leave the canister for at least 24 hours with opened valve so the pressure inside will be reduced completely. − Smash the weak spot (on top of canister, by the valve) so any solvent residue can evaporate and the canister can be disposed as scrap metal. Installation manual 1/2 IM-uk/pressurised canister spray system/23.11.11-v1 1 1- Pressurized canister – spray system with 5 metre hose and spray gun (standard). 2 2- Connect the spray gun (economy) to the hose and tighten the coupling nut correctly and firmly. 4 3 5 Spray gun (economy)
3- Control knob
4- Nozzle
5- Adhesive inlet 6- Control knob (no end-locking) 6 7 8 Spray gun (standard)
7- Control knob
8- Nozzle
9- Adhesive inlet 9 10- Connect hose to valve of canister 11- “Weak spot”. Smash for the solvent residue to evaporate. 10 11 11 Installation manual 2/2 IM-uk/pressurised canister spray system/23.11.11-v1