Transcript
RADIO EQ STACK
TUNERS / CASSETTE / DISC PLAYERS MINI
STAN
DIN
SINGLE DBL DIN
ISO DIN
CHASSIS H
13/4-2
2
2
2
37/8
3
CHASSIS W
71/8
71/8
71/8
7
71/8
71/8
CHASSIS D
43/4-51/2
57/8-611/16
57/8-611/16
57/8-611/16
57/8-611/16
57/8-611/16
NOSE H
15/8-13/4
15/8-13/4
23/8
113/16
33/4-4
NOSE W
41/8-43/16
41/8-43/16
71/2
611/16
611/16-71/4
SHAFT SP.
51/8-53/4
51/8-6
UPDATED THROUGH '99 2000 2001 2002
INFINITI 1997-UP Q-45 Sedan
IN DASH APPLICATION NOTES K
K
KS
K
P
TN2150 *
APPLICATION KIT MODEL: NN03
HARNESS ADAPTOR:
K
NDA
ANTENNA ADAPTOR:
IN-DASH INSTALLATION AREA DIMENSIONS MAX DEPTH
DEPTH 7
7 /8"
CAVITY DASH OPENING
TYPE:
DASH MATERIAL:
WIDTH
7
7 /4"
51/2"
615/16"
41/8"
7 /8"
DOUBLE DIN ISO
PLASTIC
HEIGHT
3
THICKNESS:
1
/16"
REMOVE REAR SUPPORT MODIFY CAVITY
FOR MAX DEPTH
AMPLIFIER/EQ MOUNTING LOCATIONS (WxHxD) UNDER/IN DASH
UNDER SEAT N/A Power
GLOVE BOX
TRUNK/ CARGO Various
Dimensions shown are inches. For inch/mm conversions refer to chart section.
NOTE: Scosche FAI-1B and FAINN03 interface/harness recommended for head unit replacement.
NOTE: THIS MANUAL IS BASED ON CAREFULLY DOCUMENTED RESEARCH. ABSOLUTE ACCURACY IS ATTEMPTED BUT NOT GUARANTEED. USE THIS MANUAL AS A REFERENCE GUIDE. SCOSCHE, INC. CANNOT BE RESPONSIBLE FOR INCONSISTENCIES THAT MAY OCCUR.
* Kit works for DIN ISO radio only.
B C1 C2 D D1 D2 D3 F1 F2 K K1 K2 K3 K4
= = = = = = = = = = = = = =
K5 = WHEN EQUIPPED WITH STANDARD TWO SHAFT RADIO/TAPE PLAYER. FABRICATE KIT WHEN EQUIPPED WITH FLAT FACE ELECTRONIC RADIO/TAPE PLAYER. KS = SCOSCHE KIT RECOMMENDED. N = NOT RECOMMENDED. EXTENSIVE MODIFICATION REQUIRED. P = PERFECT WITHOUT MODIFICATION. P1 = MODIFY OR REMOVE POCKETS. P2 = COIN POCKET LOCATION IN DASH (MAY REQUIRE TRIM KIT). P3 = PERFECT WHEN EQUIPPED WITH STANDARD TWO SHAFT RADIO, K WITHOUT. R = REAR LOAD ISOMOUNT. U = UNDERDASH. W1 = WITH POWER WINDOWS ONLY. W2 = WITHOUT POWER WINDOWS ONLY.
BACK UP PLATES REQUIRED. CUT TRIM/PLASTIC (STRUCTURE). CUT STEEL. BELOW DECK ONLY. LIFT PORTION OF DECK. (MAY REQUIRE STRUCTURAL REINFORCEMENT). CUT STEEL WHEN TOP MOUNTED. DO NOT IF BELOW DECK. NARROW SURFACE, BELOW DECK ONLY. MINIMUM MODIFICATION FILE SHAFT HOLES OR DASH OPENING. MODIFY DASH CAVITY AND/OR PANEL. INSTALLATION KIT, SPACER OR ADAPTOR REQUIRED. KIT MODIFICATIONS REQUIRED. EXTENSION KIT RECOMMENDED. WHEN EQUIPPED WITH FACTORY "ELECTRONIC" RADIO. FABRICATE PANEL/BRACKETS.
129
©
1997-UP INFINITI Q45 SEDAN
DASH WITH AFTERMARKET RADIO AND SCOSCHE TN2150 POCKET.
FRONT DOOR 7" 4 - HOLE IN FACTORY ADAPTER.
PRELIMINARY: DISCONNECT THE NEGATIVE BATTERY CABLE
REAR DOOR SPEAKER INSTALLATION: NOTE: THE FACTORY SPEAKER PROVISION IS FOR A BOSE 51/4" 4-HOLE PIN CUSHION SPEAKER IN A METAL FACTORY ADAPTER RING. 1. POP OFF DOOR RELEASE/LOCK ASSEMBLY TRIM AND EXTRACT (1) 10 MM BOLT. 2. POP UP PADDED ARMREST AND REMOVE (2) 10 MM SCREWS FROM DOOR PANEL. 3. POP OUT ASH TRAY AND EXTRACT (1) SCREW FROM THIS LOCATION. 4. CAREFULLY POP UP POWER WINDOW SWITCH PANEL FROM THE BACK EDGE FIRST, UNPLUG, AND REMOVE. 5. USING A PANEL REMOVAL TOOL PRY OUT AROUND THE SIDES AND BOTTOM OF DOOR PANEL TO RELEASE THE PANEL FASTENERS. 6. LIFT DOOR PANEL UP AND AWAY FROM DOOR, UNPLUG ANY REMAINING LIGHTS/CONNECTORS, AND REMOVE PANEL. 7. EXTRACT (4) SCREWS HOLDING SPEAKER IN, UNPLUG AND REMOVE SPEAKER.
ANTENNA: THE FACTORY ANTENNA SYSTEM IS A DIVERSITY SYSTEM WITH A COMBINATION OF A POWER ANTENNA LOCATED IN THE RIGHT REAR FENDER ALONG WITH AN ANTENNA IN THE REAR WINDOW GLASS.
RADIO REMOVAL AND IN-DASH INSTALLATION: NOTE: (1): THE FACTORY RADIO PROVISION IS FOR A DOUBLE DIN ISO STEREO ASSEMBLY THAT FITS BEHIND THE DASH BEZEL. FOR SINGLE DIN AFTERMARKET APPLICATIONS, WE RECOMMEND THE USE OF A ISO MOUNT DIN RADIO USED WITH A SCOSCHE TN2150 POCKET. AN INSTALLATION KIT IS NOT REQUIRED FOR MOST AFTERMARKET DOUBLE DIN STEREOS. NOTE: (2): FOR AFTERMARKET STEREO INSTALLATIONS, SCOSCHE INDUSTRIES RECOMMENDS AN "FAI" FACTORY AMP INTERFACE AND AN "FAINN03" HARNESS FOR BOSE VEHICLES. NOTE: (3): THE FACTORY BOSE AMPLIFIER IS LOCATED IN THE TRUNK UNDER THE REAR DECK. 1. CAREFULLY POP OUT THE DASH VENT/TRIM ASSEMBLY AND EXTRACT (4) SCREWS FROM BEHIND. 2. LIFT CONSOLE/ARMREST TO ACCESS LOWEST STORAGE COMPARTMENT. 3. POP OUT TRIM/LATCH ASSEMBLY TO ACCESS (2) SCREW AND REMOVE THEM. 4. REMOVE CONSOLE/GEAR SHIFT TRIM, UNPLUG LIGHTER/ASHTRAY AND REMOVE 5. EXTRACT (4) SCREWS FROM LOWER RADIO/CONSOLE TRIM. 6. CAREFULLY LIFT AWAY AND UNPLUG COMPLETE RADIO/CONSOLE ASSEMBLY, TO REMOVE. 7. EXTRACT 4 SCREWS FROM EACH SIDE OF DOUBLE DIN RADIO TO REMOVE THE RADIO FROM CONSOLE ASSEMBLY
REAR DECK SPEAKER INSTALLATION: NOTE: THE FACTORY SPEAKER PROVISION IS FOR A BOSE 7" 4-HOLE PIN CUSHION SPEAKER. AN ADAPTER IS RECOMMENDED WHEN INSTALLING AFTERMARKET 51/4" AND 61/2" SPEAKERS. WE RECOMMEND THE SCOSCHE SAC656 SPEAKER ADAPTERS. 1. REMOVE REAR SEAT UPPER AND LOWER CUSHIONS, AND SLIDE REAR DECK MATERIAL FORWARD. 2. EXTRACT (4) SCREWS HOLDING SPEAKER IN, UNPLUG AND REMOVE SPEAKER.
FRONT DOOR SPEAKER INSTALLATION: NOTE: THE FACTORY SPEAKER PROVISION IS FOR A BOSE 7" 4-HOLE PIN CUSHION SPEAKER IN FACTORY ADAPTER. AN ADAPTER IS RECOMMENDED WHEN INSTALLING AFTERMARKET 51/4" AND 61/2" SPEAKERS. WE RECOMMEND THE SCOSCHE SAC656 SPEAKER ADAPTERS. THERE IS A 1" DOME TWEETER BEHIND THE INSIDE MIRROR COVER TRIM. DOOR SPEAKER: 1. POP OFF DOOR RELEASE/LOCK ASSEMBLY TRIM AND EXTRACT (2) 10 MM BOLTS. 2. POP UP PADDED ARMREST AND REMOVE (2) 10 MM SCREWS FROM DOOR PANEL, AND (1) 10 MM BOLT HOLDING BOTTOM OF DOOR PULL. 3. CAREFULLY REMOVE DOOR PULL HANDLE LOOP. 4. CAREFULLY POP UP POWER WINDOW SWITCH PANEL FROM THE BACK EDGE FIRST, UNPLUG, AND REMOVE. 5. USING A PANEL REMOVAL TOOL PRY OUT AROUND THE SIDES AND BOTTOM OF DOOR PANEL TO RELEASE THE PANEL FASTENERS. 6. LIFT DOOR PANEL UP AND AWAY FROM DOOR, UNPLUG ANY REMAINING CONNECTORS, AND REMOVE PANEL. 7. EXTRACT (4) SCREWS HOLDING SPEAKER IN, UNPLUG AND REMOVE SPEAKER. TWEETER: 1. EXTRACT (2) SCREWS FROM BOTTOM OF TWEETER PANEL, AND REMOVE. PRY OUT ON PLASTIC PILLAR PANEL TO RELEASE SNAP CLIPS AND REMOVE. 2. EXTRACT (1) SCREW HOLDING TWEETER ASSEMBLY, UNPLUG AND REMOVE.
FRONT DOOR 1" TWEETER PROVISION.
130
©1998 SCOSCHE INDUSTRIES, INC.
1997-UP INFINITI Q45 SEDAN
REAR DOOR 51/4" MIDRANGE.
REAR DECK BASS DRIVER.
AMP LOCATION UNDER LEFT REAR DECK.
DASH/CONSOLE ASSEMBLY.
FACTORY DASH PANEL.
131
©1998 SCOSCHE INDUSTRIES, INC.
