Transcript
inspiro with iLapel microphone and MLxi Quick Reference Guide A pupils radio aid system consists of two parts FM Transmitter (worn by teacher) FM Receivers (worn by pupil)
Key
Audio Shoes
For audio shoe advice visit www.phonak.com/eschooldesk
inspiro transmitter (worn by teacher)
MLxi receivers (worn by pupil)
Inspiro can be worn using either…Belt Clip OR Lavalier Cord
1
On/Off Switch
2
Monitor
3
Mic Mute
4
Synchronise
5
Keylock / Back
6
Up / Down
7
OK
8
Audio In
9
Mini USB
1
2
3
4
5
6
7
8
Audio Input To release the belt clip Squeeze the clip release Slide the clip off the inspiro button.
On/Off Slide Switch To turn on, click the slider to the left. You will see a green mark and the LCD will turn on. Microphone Mute To toggle between mic active and inactive, push the mute button. mic active mic inactive Synchronise To Synchronise the receivers, push the sync button within 50cm of the receivers Keylock To activate keylock, push the key button, and then the OK button. To deactivate the keylock, repeat this process.
9
Charging
To Release the lavalier cord Simply pull the clip out of the inspiro button.
IF
➔
Standard 3.5mm audio cable
Using iLapel
✓
Using MLxi Important • Face the iLapel the correct way, as shown. • Do not cover microphone holes • Fully extend the iLapel cable for maximum effective range
Phonak’s MLxi is the most sophisticated, yet easiest to use receiver in the world. Simply attach the MLxi to the hearing instrument using the correct audio shoe If necessary, synchronise the MLxi using the inspiro transmitter - start teaching!
3 pin Euro connector Push button (Disabled)
For more information about your inspiro and how to use other functions please consult the user manual, or visit www.phonak.com/eschooldesk
OR
✓
inspiro with iBoom microphone and MLxi Quick Reference Guide A pupils radio aid system consists of two parts FM Transmitter (worn by teacher) FM Receivers (worn by pupil)
Key
Audio Shoes
For audio shoe advice visit www.phonak.com/eschooldesk
inspiro transmitter (worn by teacher)
MLxi receivers (worn by pupil)
Inspiro can be worn using either…Belt Clip OR Lavalier Cord
1
On/Off Switch
2
Monitor
3
Mic Mute
4
Synchronise
5
Keylock / Back
6
Up / Down
7
OK
8
Audio In
9
Mini USB
1
On/Off Slide Switch To turn on, click the slider to the left. You will see a green mark and the LCD will turn on.
2
3
4
5
6
7
8
Audio Input To release the belt clip Squeeze the clip release Slide the clip off the inspiro button.
Microphone Mute To toggle between mic active and inactive, push the mute button. mic active mic inactive Synchronise To Synchronise the receivers, push the sync button within 50cm of the receivers Keylock To activate keylock, push the key button, and then the OK button. To deactivate the keylock, repeat this process.
9
Charging
To Release the lavalier cord Simply pull the clip out of the inspiro button.
IF
➔
Standard 3.5mm audio cable
Using MLxi
Wearing iBoom A B Open loop and put iBoom over ear
✓
Tighten iBoom loop around ear
Adjust iBoom as required and use clip
A. Do not bend B. Do not pull/twist
Phonak’s MLxi is the most sophisticated, yet easiest to use receiver in the world. Simply attach the MLxi to the hearing instrument using the correct audio shoe If necessary, synchronise the MLxi using the inspiro transmitter - start teaching!
3 pin Euro connector Push button (Disabled)
For more information about your inspiro and how to use other functions please consult the user manual, or visit www.phonak.com/eschooldesk
OR
✓
