Transcript
installation guide 1
! Open carefully !
Inside: 2 big support cushions, 3 wrist pads. 1 mouse bag, 1 plastic support case, Velcro tape (inside the mouse bag) and 1 envelope with the documents (Flyer, installation guide).
Depending on model: 1 USB hub, 16 ft. (5 m) USB 3.0 cable.
3
Components on the right hand side.
2
2a
4
Attach the mouse bag to the front of the support case. You can choose the most suitable position for optimal accessibility. The position on the picture is perfect for right handed people. 5
If you need them you can use the wrist pads on the support case, by attaching them to the most suitable position.
6
Your Couchmaster should look something like this. Proceed by installing your keyboard and mouse.
©2016 by nerdytec.com • illustrations by wappworx.com
7
Turn the support case around and remove the 6 screws. Now you can open the case by pulling the slots.
8
Pass the keyboard and mouse cable through the hole shown from outside. Attach the mousepad and keyboard with Velcro tape (inside the mouse bag) on the support case if you wish. 9
10
Fix the USB hub inside with the Velcro tape. The best position is the side in which you use to take out the USB cable that goes to the computer. Then connect all devices ( mouse, keyboard and headset) to the USB hub. The micro USB cable that will be connected to the USB cable must be connected on the head of the USB hub.
After you‘ve installed all devices, close the support case and fasten the screws.
11
Lastly, connect the micro USB cable to the active USB extension cable and plug it into your computer.
Thanks for thrusting in our products and have much fun with your exclusive COUCHMASTER ®
Zum Scheider Feld 6c 51467 Bergisch Gladbach nerdytec.com
[email protected] +49 2202 9276614 ©2016 by nerdytec.com-• illustrations by wappworx.com
