Preview only show first 10 pages with watermark. For full document please download

Installation Guide For Lexcom Home ¥ Installation

   EMBED

Share

Transcript

One switch on the front provides a switchable 100 W / termination on the S0-bus. Installation Guide for LexCom Home® ISDN Tele Splitter module T110 ¥ Installation 1. Mount the module on the middle DIN rail. It is recommended that the module is positioned in the centre of this rail due to its low level of heat generation. 2. Connect the ISDN line from the NT box (S0-bus). Lexel no.: 30 633 0008 EAN nr.: 57 03 302 104 975 Configuration The factory setting of the switch is at 100 W. The NT box should be set to “100 W" as well to obtain a proper configuration. If necessary, due to unusual circumstances, the switch can be set to ¥ to reduce the load on the ISDN line. Note! The CE label on the side acts as a seal. If this seal is broken the guarantee is not valid. The short passive S0-bus is without internal power supply distribution. Technical data Application The ISDN module is exclusively used in LexCom Home. Inputs Outputs Operation temperature 1 ISDN S0-bus RJ45 Jack Splitted ISDN S0-bus RJ45 Jack 0º C to +40º C It is designed to be fitted to a DIN rail. The module is a passive component splitting an ISDN line into eight outputs. The S0-bus supported operates on the "short passive bus" principle. Construction On top of the ISDN module there is an RJ45 port to connect the ISDN S0-bus (figure1). Figure 1 : The ISDN module viewed from above On the front are eight ISDN RJ45 ports to which ISDN telephones and modems can be connected (figure 2). S0 ISDN 100 W ¥ Tele T110 ISDN Figure 2 : Front view of the ISDN module 019D7681_01 © LK a/s 09/2001