Transcript
Installation Instructions IMPORTANT: SAVE FOR THE LOCAL ELECTRICAL INSPECTOR'S USE Information is subject to change. Please refer to our website to obtain the most current product specification, technical & warranty information.
ESW 6380 / ESW 6580 / ESW 6680 ESW 6780 / ESW 6880 To prevent accidents and machine damage read these instructions before installation or use.
IMPORTANT SAFETY INSTRUCTIONS ~ Before installation make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. This data must correspond in order to avoid risk of damage to the appliance. If in doubt, consult a qualified technician. ~ The electrical outlet should be easily accessible after installing the unit. ~ The gourmet warming drawer must
be installed only in combination with other appliances specified by Miele. When installed with other appliances, the warranty is void since the manufacturer cannot guarantee the safe use of the warming drawer.
~ A solidly installed base must be present for the installation of the gourmet warming drawer and the combination device to ensure the required load carrying capacity for both appliances. ~ The combination appliance is placed directly onto the installed gourmet warming drawer; an intermediate base is not required. ~ The appliance must be installed in such a manner that the contents of the dishes can be seen. Scalding due to spilling of hot food can be avoided. Sufficient space must be given to pull the drawer out.
24
~ The gourmet warming drawer is
available in two variants differing in height. The required niche dimensions result from the installation dimensions of the gourmet warming drawer and the installation dimensions of the combination device. Note to the installer: Please leave these instructions with the consumer of the appliance for the local building inspectors use.
SAVE THESE INSTRUCTIONS
Installation dimensions Solo installation
Side view a Fixed shelf
* Appliances with glass front ** Appliances with stainless steel front
25
Installation dimensions Installation with an oven
Side view with oven
* Appliances with glass front ** Appliances with stainless steel front
26
Installation Check that the base of the warming drawer is clean and level. Only then will it function properly. When inserting the appliance, wear work gloves to avoid injuries. ^ Push the drawer into the cabinet as far as the vapor strip, and align it.
^ Open the drawer, and use the 4 screws provided to secure the drawer to the side walls of the cabinet. ^ Install the combination appliance according to the manual included with that appliance.
27
Installing the front panel ESW 6380 FB The front panel must be at least 3/4" (19 mm) thick and made of heat resistant material 140° F (60° C). The front panel, including handle, must not exceed 11 lb (5 kg) in weight. ^ Attach the handle to the front panel using countersunk screws. ^ Remove the screws from the left and right sides of the drawer front and carefully lift the control panel out. Be
careful not to pull on or damage the power cord. ^ Remove the two screws on the inside of the front and
remove the panel from the front of the drawer. ^ Pre-drill the custom front panel (see illustration). C 3/8" (10 mm), t = 3/8" (10 mm)
28
Installing the front panel
^ Remove the cable tie from the panel.
^ Screw the removed panel to the front panel (see illustration).
^ Hook the panel into the bottom. Make sure the seal is seated correctly. ^ Replace and slightly tighten the screws on the inside of the drawer front. ^ Align the front. ^ Tighten the screws on the inside of the drawer front. ^ Replace the control panel. Use caution with the power cord. ^ Replace and tighten the screws on the left and right side of the drawer front. 29
Electrical connection ,CAUTION: Before servicing,
disconnect the power supply by either removing the fuse, shutting off the power main or manually "tripping" the circuit breaker. Installation work and repairs should only be performed by a qualified technician in accordance with all applicable codes and standards. Repairs and service by unqualified persons could be dangerous. Before connecting the appliance to the power supply, make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. This data must correspond to prevent machine damage. Consult an electrician if in doubt. When another appliance is installed in combination with the warming drawer to the same circuit, operating both appliances at the same time may cause an overload. If in doubt consult a qualified electrician.
30
Power supply This appliance is equipped with a 5 ft (1.5 m) long power cord with a three-prong grounding plug ready for connection to a 120 V, 15 A, 60 Hz power supply. Further installation details are on the wiring diagram.
NEMA 5-15P, 15 amp, 120 VAC, L1, N, G
Technical Service In the event of a fault which you cannot easily fix yourself, please contact the Miele Technical Service Department at the address on the back of this booklet. When contacting Technical Service please quote the serial number and model of the appliance. This information is visible on the silver data plate supplied with the appliance.
MieleCare (USA only) MieleCare, our Extended Service Contract program; gives you the assurance of knowing that your appliance investment is covered by 5 years of worry free ownership. MieleCare is the only Extended Service Contract in the industry that guarantees repairs by a Miele Authorized Service Provider using genuine Miele parts. Only genuine Miele parts installed by factory trained professionals can guarantee the safety, reliability and longevity of your Miele appliance. Please note that unless expressly approved in writing by the Miele Service department, Extended Service Contracts offered by other providers for Miele products will not be recognized by Miele. Our goal is to prevent unauthorized (and untrained) service personnel from working on your Miele products, possibly doing further damage to them, you and/or your home. To learn more about MieleCare Extended Service Contracts, please contact your appliance dealer or visit us online at: http://mieleusa.com/mielecare
31
Help protect our environment Disposal of packing materials
Disposal of an old appliance
The cardboard box and packing materials are biodegradable and recyclable. Please recycle.
Old appliances contain materials that can be recycled. Please contact your local recycling authority about the possibility of recycling these materials.
Ensure that any plastic wrappings, bags, etc. are disposed of safely and kept out of the reach of children. Danger of suffocation!
32
Before discarding an old appliance disconnect it from the electrical supply and cut off the power cord to prevent it from becoming a hazard.
33
34
INFORMATION IS SUBJECT TO CHANGE. PLEASE REFER TO OUR WEBSITE TO OBTAIN THE MOST CURRENT PRODUCT SPECIFICATIONS, TECHNICAL & WARRANTY INFORMATION.
35
ESW 6380 / ESW 6380 FB / ESW 6580 / ESW 6680 / ESW 6780 ESW 6880 en - US, CA
M.-Nr. 09 800 170 / 00
