Installation Instructions

Transcript

FutureLinkTM VDSL2 Splitters Installation Instructions 649NV-48 100643-00 Rev. A 649NV-48: VDSL2 NID Splitter VDSL2 NID SPLITTER Installation: 1. With the Telco access cover open snap the module into the NID sliding the right side under the latch and rocking the left side into the latched position. 2. Open the cover to disconnect the network input and access the distribution connectors. 3. Route the network leads to the Telco access compartment and terminate as suggested by the NID manufacturer. 4. Terminate voice runs to the distribution connectors as described below. 5. Terminate the data run to the distribution connector as described below. 6. Close the cover to complete the circuit from the network input to the distribution connectors. Distribution Disconnect Plug Distribution Connectors Test Jack Network Leads Distribution Connectors: A. Lift the toggle to the open position B. Insert unstripped wires into the corresponding wire holes C. While holding the wires firmly in place push down on the toggle, until it bottoms, terminating the wires. Voice 1 Voice 2 Data Voice 3 Testing: 1. Open the cover to disconnect the network input. 2. Plug tester into the test jack. A. The center pair of the test jack will verify the incoming service line B. The outer pair of the test jack will verify distribution connections Distribution (T) Network (R) Important Information: • Read and understand all instructions. Follow all warnings and Do not use this product near water,--e.g., near a bath tub, wash • Never install communications wiring or components during a • Never touch uninsulated wires or terminals unless the wiring • Never install communications components in wet locations lightning storm. basin, kitchen sink, wet basement, or near a swimming pool. • • Never push objects of any kind into this product through Network (T) Safety Information: instructions marked on the product. • Distribution (R) has been disconnected at the network interface. openings, as they may contact dangerous voltages. unless the components are designed specifically for use in SAVE THESE INSTRUCTIONS. wet locations. East manuals, Hwy 212 For more information or1001 to download please visit: suttlesolutions.com/technical-literature/ Hector, MN 55342 www.suttleonline.com Toll Free: 1-800-852-8662 Local: Specifications subject to change without1-320-848-6711 notice. Copyright 2015. 100643-00 Rev. A Fax: 320-848-6218 1001 East Highway 212 • Hector, MN USA 55342 • suttlesolutions.com Toll Free: 1 (800) 852-8662 • Local: (320) 848-6711 • Fax: (320) 848-6218