Installation Instructions

Transcript

Installation Instructions SPECIALTY LIGHTING ***URGENT: READ PRIOR TO ATTEMPTING INSTALLATION*** - MINI TOUCH DIMMER Always turn off main power before installation Item# Description NAL-255 Mini Touch Dimmer Rating INSTALLATION SHOULD BE CARRIED OUT BY YOUR LOCAL ELECTRICIAN. 24V 0.16W Stand By Power Caution: • Disconnect the power (adapter) before installing/removing the device. • Do not disassemble, repair, or modify the device. • Do not use this device near water (For example: Bathtub, pool, sinks, or laundry tub). • Keep the device dry. • Never push objects of any kind through slots or openings into the device or connectors. • This product should only be operated from the type of power source indicated on the data sheet. • Do not scratch the sensor cover. • Included grey power line connector MUST be used in order for mini touch dimmer to work properly. Operation Description: 1. On/Off: Use your finger to touch the sensor area shortly. (Single touch, ~0.5 seconds, see Fig. 1). Note: If the system using the Mini Touch Dimmer is connected to a wall switch, the switch can only shut system off. The system requires a manual touch to come on. 2. Dimmer: Continue to hold the finger on the sensor area, it will dim the lightbar’s brightness in a cycling pattern. Remove your finger when it reaches the desired brightness. (See Fig. 1) 3. Brightness Setting Memory: The previous selected brightness is stored until the adapter plug is disconnected or when power has been interrupted. 4. System Configuration: Mini dimmer can be installed at any place in a lightbar chain or network. Several scenarios are illustrated below. Fig. 1 Release sensor at desired brightness level. Brightness Level Touch sensor to turn off. Sensor cycles from low to high brightness when engaged. Touch sensor to turn on. Sensor displays at previously selected brightness level until changed or power is disconnected. Sensor Control Installation Instructions: 1. Select where the mini touch dimmer is to be positioned in the Lightbar System. Refer to drawings below for possible locations. 2. Included power line connector MUST be used to power the system. Using appropriate interconnectors complete the system. When attaching in-line dimmer directly to lightbar with end to end connector, bar to bar joiner (included) must be used for rigidity. 3. Use included power line connector for connecting the Nora Driver when a mini touch dimmer is installed anywhere in a lightbar chain or network. 4. Plug the power (adapter) to an AC line. 5. Touch the dimmer and enjoy it. Dimmer Standard Lightbar Interconnection Cable LED Lightbar End to End Connector (Included) LED Lightbar Power Line Interconnector (Included) Nora Driver Dimmer LED Lightbar Standard Lightbar Interconnection Cable Standard Lightbar Interconnection Cable LED Lightbar Power Line Interconnector (Included) Nora Driver Dimmer LED Lightbar End to End Connector (Included) LED Lightbar Standard Lightbar Interconnection Cable Power Line Interconnector (Included) Mini Touch Dimmer at the end of chain Mini Touch Dimmer at the middle of chain Mini Touch Dimmer at the beginning of chain Nora Driver 6505 Gayhart St., Commerce, CA 90040 www.NoraLighting.com Page 1 of 1