Installation Instructions

Transcript

8 6 7 INPUT CONNECTOR 5 4 EQUIPMENT BRACKET (NOT INCLUDED) 2" CONTROL HEAD HEIGHT MINIMUM WASHER HEX NUT 2 1 INSTALLATION INSTRUCTIONS: LOCK WASHER D 3 IMPORTANT: REMOTE POWER BUTTON CABLE MUST BE ASSEMBLED TO EQUIPMENT BRACKET PRIOR TO CONNECTING TO DOCKING STATION. FAILURE TO DO SO WILL INCREASE REQUIRED INSTALLATION TIME. D 1. INSERT INPUT CONNECTOR END OF POWER BUTTON CABLE THROUGH WASHER, EQUIPMENT BRACKET, LOCK WASHER, THEN HEX NUT, AS SHOWN IN ILLUSTRATION 1. NOTE: IF EQUIPMENT BRACKET IS BLANK AND DOES NOT INCLUDE A THRU HOLE LOCATION FOR THE REMOTE POWER CABLE, A HOLE MUST BE DRILLED. USE A MINIMUM 3/4" AND MAXIMUM 7/8" DIAMETER DRILL BIT TO DRILL HOLE. POWER BUTTON 2. MAKING SURE THAT POWER BUTTON IS IN CORRECT ORIENTATION (SEE ILLUSTRATION 2), TIGHTEN HEX NUT TO FASTEN POWER BUTTON CABLE ONTO EQUIPMENT BRACKET. TORQUE TO 35 IN-LBS. ILLUSTRATION 1: EQUIPMENT BRACKET/POWER BUTTON CABLE ASSEMBLY C 3. INSTALL EQUIPMENT BRACKET/POWER BUTTON CABLE ASSEMBLY ONTO CONSOLE PER EQUIPMENT BRACKET INSTALLATION INSTRUCTIONS. POWER BUTTON CABLE IS SHOWN INTENTIONALLY SHORT IN THIS VIEW (ACTUAL LENGTH IS APPROXIMATELY 20 FEET) C 4. ROUTE POWER BUTTON CABLE TO THE DOCKING STATION. 5. CONNECT INPUT CONNECTOR END OF CABLE TO REMOTE POWER CONNECTOR LOCATED ON FRONT OF DOCKING STATION (SEE DETAIL VIEW A). A NOTE: MAKE SURE CABLE HAS GRADUAL BENDS TO PREVENT DAMAGE TO CABLE. EXCESS CABLE LENGTHS SHOULD BE ROUTED INTO A CIRCULAR LOOP WITH AS LARGE A DIAMETER AS POSSIBLE. KEEP CABLES OUT OF PINCH ZONES. B B 6. USE ZIP TIES TO STRAIN RELIEVE CABLE. ZIP TIES SHOULD BE ADJUSTED LOOSE TO SNUG TO PREVENT DAMAGE TO CABLE. NOTE: REMOTE POWER BUTTON FUNCTIONALITY MIRRORS LAPTOP POWER BUTTON. REFER TO LAPTOP USER'S GUIDE FOR INSTRUCTIONS ON HOW TO USE. ILLUSTRATION 2 DETAIL VIEW A A DS-DA-318_INST_9-16 7 6 5 09-28-16 PRODUCT NAME REMOTE POWER CABLE WARNING: ALL HAVIS INC. PRODUCTS ARE DESIGNED WITH SAFETY OF USE AND INSTALLATION IN MIND. HOWEVER, PRODUCT DESCRIPTION IT IS THE SOLE RESPONSIBILITY OF THE OWNER/OPERATOR OF A VEHICLE USING HAVIS INC. MOUNTING AND DOCKING EQUIPMENT, TO INSURE THAT THE EQUIPMENT IS INSTALLED SO THAT IT WILL NOT INTERFERE WITH VEHICLE REMOTE POWER BUTTON CABLE OPERATION, INTERFERE WITH SAFETY DEVICES, OBSTRUCT VIEW OF DRIVING CONDITIONS, OR IN ANY WAY DEGRADE OCCUPANT SAFETY. IMPROPER INSTALLATION CAN CAUSE SERIOUS INJURY IN THE EVENT OF AN INSTALLATION INSTRUCTIONS. FOR USE ACCIDENT. INSTALLATION SHOULD ONLY BE PERFORMED BY QUALIFIED PROFESSIONALS. COMPUTERS AND WITH DS-GTC-605 DOCKING STATIONS MOTION DEVICES MUST BE MOVED TO AND STOWED/SECURED IN THEIR SAFE DRIVING POSITIONS BEFORE OPERATING VEHICLE. DRAWING NUMBER: 8 DS-DA-318 CORRECT POWER BUTTON ORIENTATION DS-GTC-605 REMOTE POWER CONNECTOR DATE PRODUCT I.D. 4 3 WEIGHT: (LBS) 0.03 REV. DATE 09-28-16 1-800-524-9900 WWW.HAVIS.COM 2 1 F-730-019 REV A A