Installation Instructions Combination Volleyball System By Draper Caution

Transcript

Installation Instructions Combination Volleyball System by Draper Caution 1 Overtightening top cable can damage equipment and possibly cause injury. 2 The center of the net will sag slightly. This is natural. Do not try to compensate by over-tightening top cable. (See “Net Height” information below.) 3 Make sure proper parts and accessories have been shipped. Do not attempt to install any accessories that are not recommended for your Combination Volleyball System. 4 Do not attempt to operate the winch by using an electric drill; hand crank only. 10 Unspool the 2" nylon strap from winch. Hook one end of the top net cable in hook on belt. Hook opposite end of top net cable to cable anchor collar on the other standard. NOTE: Make sure the cable is running cleanly through sheaves. 11 Tighten net by turning winch handle clock wise. Measure distance from top of net to finished floor at the center of the net. 12 Install tensioner to winch end of bottom net rope by inserting rope through beveled end of tensioner. Tie a loop in other end of rope. Attach rope tensioner to winch and tied loop to cable anchor collar. Tighten by pulling on rope while holding tensioner. 13 Wrap 1" wide net tension straps once around standards and tighten using buckles. NOTE: Winch incorporates a worm gear type mechanism. To loosen top cable, turn winch handle counterclockwise. Age Groups 10-under 12-under 14-under 16-under 18-under 51½" (131 cm) 51½" (131 cm) 3'33/8" (1 m) These instructions are meant as a guide only. They do not imply any responsibility on the part of Draper, Inc. for improper installation or faulty workman ship at the jobsite. 1 Attach winch assembly to one of the 3½" O.D. upright tubes. Locate approximately 51½" from top end, and tighten screws with allen wrench. Install and tighten acorn (cap) nuts to cover exposed threaded end of cap screws. 1'9"± (.53 m) 1'9"± (.53 m) Combination Antenna 2 Attach cable anchor collar onto the and Boundary Marker (2) other 3½" O.D. upright tube. Locate ½" (1.27cm) fiberglass Sliding approximately 51½" from top end, and dowel rod (2) Adjustment Net tighten screws with allen wrench. Collar (2) NOTE: It will be necessary to move winch and cable anchor collar when 1" (2.54cm) wide tension using CVS volleyball system for nets straps heights other than Men’s and Women’s Volleyball. 2" (5.08cm) 3 Install one sliding adjustment collar on nylon strap each upright tube. Make sure that collar is installed so spring pin is located on same side as milled relief. Power Boundary winch 4 Install standards in floor sleeves. Rope tensioner Marker (2) Cable anchor 5 Set post to desired net height by slidcollar ing adjustment collar to desired height Folding making sure that plunger goes in to 2" (5.08 cm) wide court lines handle predrilled hole. NOTE: Proper height is stamped on side of post. Tighten threaded T-handle to keep collar secure. 3'0" (.914m) min. 3'0" (.914m) min. * Court width 6 Measure distance from finished floor 36'0" (10.97m) center to center of post to top of sheave. This dimension Floor Plate (2) should be ¾" (2 cm) higher than (Ordered 501006 3½" (8.89 cm) ID 3½" (8.89 separately) required net height shown on figure 1. Floor sleeve (Ordered separately) cm) OD * Court width If necessary, remove standard from 29'6" (8.99m) International & College sleeve and adjust rubber bumper until 30'0" (9.14m) High School Protective rubber desired height is reached. bumper (adjustable) 7 Unroll net on floor between standards. 8 Install 1/2" fiberglass rods in ends of Net Height net. Regulation net heights are measured and set at the center of the net. The 9 String net between posts by sliding ends of the net cannot exceed regulation height by more than 3/4" (2 cm), looped cable end over pulley on slidwhich allows for natural net sag. ing adjustment collar. Below are official net heights recommended by USA Volleyball: Girls 6'0" (1.83 M) 6'6 (1.98 M) 7'4 1/8" (2.24 M) 7'4 1/8" (2.24 M)* 7'4 1/8" (2.24 M)* Boys 6'0" (1.83 M) 6'6" (1.98 M) 7'4 1/8" (2.43 M) 7'11 5/8" (2.43 M)* 7'11 5/8" (2.32 M)* *Official net heights for High School, Collegiate and International Competition. (Continued on back) Copyright © 2015 Draper Inc. Form VB-CVS_Inst15 Printed in U.S.A. If you encounter any difficulties installing or servicing your Combination Volleyball System, call your dealer or Draper, Inc., Spiceland, Ind., (765) 987-7999 or fax (765) 987-7142. Combination Volleyball System by Draper Page 2 of 2 Options (Typ. installation details) 500014 Volleyball Net 32'0" Net 4" Square netting #36 Nylon cord (black) 3'3 3/8" (1 meter) 3'0" 40'6" nylon coated 1/8" aircraft cable 5000016 Combination Antenna and Boundary Marker 1" wide polypropylene tension straps with tensioning buckles 1/4" dia. braided white nylon rope 1/2" 2" dia. fiberglass dowel www.draperinc.com (765) 987-7999