Installation Instructions Infinias Wiegand Manual Type Controller For All Wiegand Access

Transcript

INSTALLATION Infinias Wiegand Manual Type INSTRUCTIONS For Wiegand Keypads, Proximity Readers and Biometric Access Devices For Models Controller for All Wiegand Access Devices Specifications Power Direct from PoE switch or external power supply (24 VDC, 1 A) Physical 1.30" D x 1.70" W x 2.82" H Environmental Operating Temp 32° to 120°F Total DC Output 750 mA (250mA max for readers) Access Control 12v DC output for gate strike and for magnetic lock Normally open and normally closed dry contact Release button (REX) LED and BUZZER inputs From PoE Switch DC Out to Mag Lock DC Out Positive DC Out to Gate Strike Request to Exit OC1 + NC C OC2 NO IN1 IN3 C IN2 NC (Normally Closed) Relay Out Relay Out Common NO (Normally Open) Relay Out 501 E. Goetz Ave. Santa Ana, Ca 92707 www.eholovision.com C IN4 D0 DO D1 D1 GND GND 12V+ 12V+ PW- LED PW+ BUZ Wiegand Data 0- Green Wiegand Data 1- White DC Out Ground- Black DC Out Positive- Red LED Buzzer Ph. 714-434-6904 Fax 800-362-0002 HOLOVISION Wiegand eKey PS LAN eKey Bio. Reader Controllers CAT5/6 For Biometric- 500’ Ethernet PoE OC NC + C OC NO IN1 IN3 C C IN2 IN4 D0 DO D1 D1 GN GN 12 12 PW LE PW BU 6 Conductor Sheilded- 350’ Max. DC Out To Gate Strike, Mag Lock, N/O to REX 12V+ 12V D0 D1 GND G-LED R-LED CODE Holovision Junction Board See individual manual for detailed Illustration IP Address When the eIDC boots up, it will flash it’s IP address with a single flash of all lights to seperate each block of the address. By default the devices will be in DHCP mode and will try to get an address from the DHCP server. Failing that they will default to 169.254.1.1. If all lights flash constantly the controller is not seeing the network. To assisgn a static IP address, browse to the eIDC by the address it flashed on boot up and log in with user ID of “admin” and password of “admin”. Once logged in , click the System button, then the Controllers button. Select the controller and click the Modify button. Uncheck the DHCP option and enter the IP address you wish to assign. If using DHCP make sure you assign a permanent lease to the controller. This prevents the IP address from changing when it’s lease expires. Navigating the Browser Once you have logged into the eIDC the first screen you are taken to is Event Monitoring. From here you can get to every other service menu. System will allow you to create time schedule for access and privilages. Events at the bottom right will take you back to monitoring. To set the correct time for the eIDC go to Control Panel, then in the upper right hand corner go to Network Status. At the bottom left hand corner there is a “Time & Date” section that allows you to manually set the correct information or you can select to Sync with the PC.