Preview only show first 10 pages with watermark. For full document please download

Installation Instructions: Product Temperature Monitor Kit Inside Tvo

   EMBED


Share

Transcript

I N S T A L L A T I O N : T V O V A C U U M P R O D U C T T E M P M O N I T O R O V E N S Installation Instructions: Product Temperature Monitor Kit Inside TVO Model Vacuum Ovens #9990034 O N I N S T A L L A T I O N : T V O V A C U U M P R O D U C T T E M P M O N I T O R O N O V E N S SAFETY PRECAUTIONS SAFETY PRECAUTIONS This is a general-purpose vacuum oven for professional, industrial or educational use. It is suitable for a working environment where no flammable, volatile or combustible materials are being heated. This oven is not intended for hazardous or household use. Your satisfaction and safety require a complete understanding of this unit. Read all instructions thoroughly and be sure all operators are given adequate training before attempting to put the unit in service. This equipment must be used only for its intended application; ANY ALTERATIONS OR MODIFICATIONS WILL VOID YOUR WARRANTY. OBEY ALL LAWS & LOCAL ORDINANCES Local city, county or other ordinances may govern the use of your vacuum oven. If you have any questions about local installation requirements, please contact the appropriate local agency. 2 503-847-9047 / [email protected] I N S T A L L A T I O N : T V O V A C U U M P R O D U C T T E M P M O N I T O R O N O V E N S COMPONENTS PRODUCT TEMPERATURE MONITOR 9990034 KIT Item Meter, hand held 2- T/C Thermocouple, Vac feed thru, 2 T/C plug, high temp male KF25 X ½” FNPT Part Number Quantity 8150005 1 4870012 1650022 3100073 1 1 1 3 503-847-9047 / [email protected] I N S T A L L A T I O N : T V O V A C U U M P R O D U C T T E M P M O N I T O R O N O V E N S INSTALLATION: PRODUCT TEMPERATURE MONITOR From the back center of the oven, remove the wing-nut clamp, cap, and O-ring from KF-25 flange on the back of the oven. Clamp O-Ring Clamp Feed the silver tipped end of the thermocouple wires through the O-ring. Feed the wires all the way inside the oven until the silver flange on the wires meets the silver flange on the oven. The O-ring sandwiches between the two silver flanges. Silver Flange Into Yellow Data logger Install the clamp and tighten the wing nut. 4 503-847-9047 / [email protected] I N S T A L L A T I O N : T V O V A C U U M P R O D U C T T E M P M O N I T O R O N O V E N S INSTALLATION: PRODUCT TEMPERATURE MONITOR Install OMEGA Temperature Monitor. Remove yellow protective case. With small screw driver, open battery pack and install 9V battery provided on back of monitor. Re-assemble case. Yellow protective cover. Plug black forked ends of thermocouple wire into the top of the OMEGA Temperature Monitor. Press the power button to turn the monitor on. Set the monitor to “Type J” thermocouple. Select degrees C or F. Refer to omega meter manual for full set of functions. The temperature reading will only be accurate if the silver tips of the thermocouple wires are physically touching. Place directly in your product, tape to a shelf, sandwich between shelf and glass Pyrex dish, etc… Silver tipped thermocouple wires inside oven 5 503-847-9047 / [email protected]