Preview only show first 10 pages with watermark. For full document please download

Installation Instructions Series 51® 44062 Chevrolet S-10 Pickup

   EMBED

Share

Transcript

SERIES 51® Installation Instructions Part Numbers: Chevrolet S-10 Pickup GMC S-15 & Sonoma Pickup Isuzu Hombre 44062 51063 Do Not Exceed Lower of Towing Vehicle Manufacturer’s Rating or Hitch type Max Gross Trailer WT (LB) Max Tongue WT (LB) Weight Distributing 5000 (2270 Kg) 500 (227 Kg) Weight Carrying Ball Mount 3500 (1589 Kg) 350 (159 Kg) Wiring Access Location: PU3 Equipment Required: Fastener Kit: 44413 Wrenches: 3/4 Socket & Wrench Drill Bits: 1/2” Note: Fasteners typical both sides 1 2 Important notes Use only Towing Products supplied or approved bolts, locknuts, and washers to install this hitch. 54 3 Warning: Do Not lubricate threads, bolt failure may occur due to over tightening. Warning: Do Not drill or weld to this hitch. 1 2 3 Qty. (2) Carriage Bolt 1/2-13 X 2.00 Qty. (2) Block Qty. (6) Flat Washer 1/2 4 5 6 3 Qty. (4) Lock Washer 1/2 Qty. (4) Hex Nut 1/2-13 Qty. (2) Bolt 1/2-13 X 1.50 6 3 4 5 1. Lift the hitch up into place between the bumper brackets. 2. Insert a 1/2” carriage bolt with the block down through the large hole at the end of the frame and into the hole in the hitch bracket. Install a 1/2” flat washer, and 1/2” lock washer, and 1/2” nut on the bolt. See diagram above. Repeat for the other side. 3. Insert a 1/2” hex head bolt with a 1/2” flat washer through the bumper bracket and into the hitch bracket. Install a 1/2” flat washer, 1/2” lock washer, and 1/2” nut on the bolt. See diagram above. Repeat for the other side. On some models the bumper brackets will have to be drilled. Use the holes in the hitch brackets as a guide to drill 1/2” holes through the bumper brackets. . Tighten all 1/2 fasteners with torque wrench to 70 Lb.-Ft. (95 N*M) Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. z 2002, 2004, 2006 Cequent Towing Products Sheet 1 of 1 44062IN 6-27-06 Rev. D Form: F205 Rev A 5-6-05