Preview only show first 10 pages with watermark. For full document please download

Installation Kit Ehs Cisco Part B

   EMBED

Share

Transcript

Installation Kit EHS Cisco Part B electronic hook switch - Remote controlled telephone system - Call control - external adapter - no software required Product code SKN 300 for: 7940 7941 7960 7961 7970 7971 Part A Part B Instruction manual for authorized specialized staff SKN 300 CENTER SERVICE- UND DIENSTLEISTUNGSZENTRUM GMBH LEIPZIG Tel.-Hotline: 0341 8684230 Zentral-Fax: 0341 8684233 E-Mail: [email protected] 04299 Leipzig Schönbachstraße 65a Wireless Headsetsolution for Cisco at IPP 79xx terminal with adapter 7 4 1 0 8 5 2 9 6 3 # * CISCO IP PHONE 7940 SERIES CISCO IP PHONE 7940 SERIES Terminal connection socket CISCO IP PHONE 79xx Serie mobil unit Headset assortment Network plug System port remote controlled IP telephone without motor management system - Operation: call pick up, call hold and call waiting using remote control - Call transfer and call placement using receiver headset Adapterwire for controlling (0,75 m) Plantronics base-CSxx/CA40 voyager wireless Headset Receiver Telephone Controlling Receiver connection socket Westernwire 4/4 (0,75 m) originale receiver wire (coiled wire) http://www.modicom.de - Sevices for adapted solutions - Adapter EHS SKN 300 final assembly lift sopport stand halfway open the phone (remove 4x bolts) lift rear side pull notches out off guiding gib on left side pull notches out off guiding gib on right side detach faceplate demount faceplate upwards push hookswitch demount clip by pushing forward open phone bolt underneath clip of hand set 1x 10 mm long 3x Positioning of attechment bolts, 4 x 8 mm long open right side and keep it open with card board open notch with flat screwdriver right side open notch with flat screwdriver left side rotate the phone, lay down and detach the rear panel Adapter installation side put rear panel down pull connector put down insert EHS adapter through port for headset jack Adapter with plug and jack Ribbon cabel with cord grip insert Adapter EHS-Modul insert adapter connect plug and jack rear panel turned connect adapter to socket on main board form wire Scroll spring! tie down helps Location of scroll spring of hook switch attach rear panel, pull wire back to mark close notches cord grip: pull wire back to mark attach rear panel using bolts fit cord grip in assembling of bolts, face plate and clip Ready to ose! press on sticky stands put wire and EHS modul underneath support stand Funktion test power supply mode of operation is self-explanatory