Transcript
VTM-1IR SINGLE INPUT IR MODULATOR
INSTALLATION MANUAL Product Diagram and Description: A
C
B
A
CHANNEL
B
VTM-1IR
UP IR
DOWN
C D E F
D
G H
IN
I Loop Through
GAIN
AC 12V Power Input
RF OUTPUT Remote Power
AUDIO R AUDIO L VIDEO
E
IR
G
H
LOOP Through Termination
K
Hi-Z 75
OFF / ON
F
J
LED IR display LED Channel display Channel up/ down Video and audio inputs Video and audio outputs, loop through RF gain control RF output Remote Power Switch IR Emitter Output AC power input 75 terminator switch
I
J
K
Hardware Connection:
Channel Selection:
1. Connect a 12V AC power pack to the power input J
1. Push the UP or DOWN button C to set the desired channel. After 15 seconds the channel will be automatically stored in the Modulator's memory. In the instance of a power outage, the channel will be saved in memory.
2. Connect the RCA cable from the video source (e.g. CABLE/ PAY TV, DVD, VCR, CAMERA) to the top yellow RCA video input jack D on the rear of the VTM1 Modulator. 3. Connect the RCA cable from the audio source to the top red/ white input audio jacks D on the rear of the VTM-1 Modulator. Use red and white jacks for dual input, or either one for single input. 4. Connect the RF output G from the VTM-1 to the Modulator input on the Video Distribution Unit (see Video Distribution Unit operating instructions). Alternatively, connect the RF output G to an exiting distribution system or directly to a television set.
5. Move the Remote Power switch H on the rear of the VTM-1IR to "ON" if you would like the Modulator to power a Video Distribution Unit. 6. Connect IR emitters to the outputs I on the rear of the VTM-1IR Modulator. Place the other end within 25cm of the IR receiver on the Video source (depending on environmental conditions).
PTY LTD
PO Box 2072 Camberwell West 3124 Melbourne, Australia Tel: 61-3-9809-4411 Fax: 61-3-9809-1841 Email:
[email protected]
Loop through Facility: 1. Connect another set of RCA cables from the bottom RCA jacks (video and audio) E to the AV inputs on your TV. 2. When the loop through RCA jacks E are being used position the 75 terminator switch K to Hi-Z. If not then position to 75
Power Adjustment: 1. Use a screwdriver to gently rotate the RF Gain control knob F on the rear of the VTM-1 Modulator. Rotate clockwise to increase the output and counter clockwise to decrease the output.
ACN: 091 281 524 ABN: 99 091 281 524 WARRANTY VCOMM Pty Ltd states that the warrant that the customer can rely on is that provided by the manufacturer. In the event of any warranty claim please contact us and we will forward it to the manufacturer. The manufacturer will then determine the extent of their liability. This expressly negates, to the extent possible by Australian law, any warranty reliance on VCOMM Pty Ltd.
