Transcript
FS-529 Finisher INSTALLATION MANUAL Applied Machines: d-Color MF360/MF280/MF220 COLOR MFP: 36 ppm/28 ppm/22 ppm Product Code: A0ED
I. Accessory parts No.
Name
Shape
Note: • This manual provides the illustrations of the accessory parts and machine that may be slightly different in shape from yours. In that case, instead of the illustrations, use the appearance of your machine to follow the installation procedure. This does not cause any significant change or problem with the procedure. • Be sure to hold onto the portions shown in the illustration when taking the Finisher Unit out of the box.
Q’ty
1. Finisher 1
A0U7IXC001DA
2. Screw A (3 × 6 mm)
1 9646
3. Screw B (3 × 14 mm)
1 4551IXC028DA
4. Label 1
5. Installation manual 1 set A0U7IXC002DA 4980IXC019DA
After unpacking, be sure to get rid of the packaging materials and keep them out of the reach of children. Putting the head in the plastic bag involves danger of suffocation.
Y111110-1
E-1
Installation Manual
II. Installation procedures
4. Remove the output tray if it is mounted on the machine. * Remove it while pushing the claws of the output tray in the direction of the allow ➀ shown on the illustration and unhook.
1. Turn off the machine’s sub and main power switches, and unplug the power cord from the outlet. 2. Remove protective tapes and shipping material and take out accessory parts. Note: Slide the finisher while pushing the lever. Remove the shipping material A. A
➀
lever
➀
A083IXC006DB
5. Peel the seal off the machine.
Seal A0U7IXC013DA
3. Remove the finisher cover with a flat-blade screwdriver.
A0U7IXC004DA
6. Remove the cover from the main body as shown in the illustration (One screw).
A0U7IXC003DA
A083IXC033DA
Installation Manual
E-2
Y111110-1
10. Hold the finisher by the locations as shown in the illustration and put it on the rail of the main body.
7. Remove the indicated filter.
A0U7IXC005DA
8. Remove the cover from the main body as shown in the illustration (Three screws).
A0U7IXC008DA
11. Slide the finisher to the rear and set in position.
A0U7IXC006DA A0U7IXC009DA
9. Remove the knockout from the cover removed in step 8 with nippers.
12. Secure the finisher. • ➀ : The one furnished screw A • ➁ : The one furnished screw B * Align the dowel with the dowel hole. Tighten ➀ and then tighten ➁.
A0U7IXC007DA
A0U7IXC010DA
Y111110-1
E-3
Installation Manual
III. Affix the label
13. Attach the cover removed in step 3. 14. Attach the cover removed in step 8 (Three screws). 15. Attach the filter removed in step 7. 16. Connect the hookup cord to the machine.
Slide the finisher and affix the label to the position as shown in the illustration. Note: Slide the finisher while pushing the lever.
A0U7IXC011DA
label lever
A0U7IXC012DA
Installation Manual
E-4
Y111110-1
