Preview only show first 10 pages with watermark. For full document please download

Installation/operation Manual C38-xx

   EMBED

Share

Transcript

INSTALLATION INSTRUCTIONS C38-XX SERIES SYSTEM JUMPER CORDS DESCRIPTION C38-XX Series System Jumper Cords provide intercom connection between Series 3800 Intercom System Modules. When the C38-XX is connected to any variant of Headset Station or Intercom Junction Module, that connected module becomes part of the intercom system. INSTALLATION The C38-XX has 2 each 4-pin military type screw-on connectors (one on each end). Install as follows: a. Align key-way slot on cord connector with key in threaded connector on module. b. Insert pins into socket until firmly seated. c. Hand tighten swivel nut on cord connector Figure 1. Model C38-XX System Jumper Cord Schematic Diagram 19545P-28 (07/13) © 2013 David Clark Company Inc.