Preview only show first 10 pages with watermark. For full document please download

Installation - Rfi Wireless

   EMBED


Share

Transcript

Installation CD28-41-70 Series Mopole™ Antennas 148-174 MHz The CD28-41-70 antenna is an end fed dipole (Mopole) which is ground plane independent. The antenna uses a tapered 17-7PH stainless steel radiating section in which the feed design the terminated RG58 forms part of the high impedance matching circuit. The matching circuit which is enclosed in a high impact ABS housing. For use with RG58C/U cable only Note: No D.C. continuity exists between the centre conductor of the cable and the radiating element. A short exists from the cable shield to the radiating element. To Terminate The Antenna: 1. Remove approximately 80mm of the outer PVC jacket of the RG58 cable. 2. Trim the exposed cable braid shield so that approximately 10-15mm remains showing. 3. Fold the remaining braid shield back over the outer PVC jacket of the cable as shown. 4. Trim the exposed inner conductor, complete with insulation to the EXACT length shown below. 5. Screw the prepared cable into the coil housing until the cable ‘bottoms’. The cable is now terminated. No soldering of the conductors is necessary. Please note the D.C. continuity checks above. 6. Trim whip top to frequency using an inline VSWR meter. (Chart below serves as an accurate guide if cable preparation is correct). 70mm DRAWN TO SCALE (RFI recommends checking the dimensions as variations can occur in the printing process) RG58C/U CABLE 148-175 MHz Cutting Chart 1050 1000 WHIP LENGTH (MM) 'A' 950 900 850 800 750 700 650 600 144 146 148 150 152 154 156 158 160 162 164 166 168 170 172 174 176 178 180 Frequency (MHz) The supplied cutting chart ensures the whip is always longer than required, allowing the antenna to be fine tuned. The cut length is for the whip section end to end before install. Once tuned the whip can then be installed on the base assembly and secured with the grub screw. Copyright RF Industries Pty Ltd 2014. Subject to change without notice. INS-41960-1 1 rfiwireless.com.au