Transcript
Installation steps Digital buttons only
Analog mode on/off
Digital buttons only
Battery installation Put 3xAAA alkaline battery according to polarization marks. Driver installation First install driver, then plug USB receiver into PC computer. Put software CD in to CD-ROM driver and follow on-screen messages. When driver is successfully installed you can plug USB receiver into USB port and switch on the pad. Windows new hardware wizard will install new device.
Manipulators (can work in analog or digital mode)
USB RF receiver
Analog LED Battery compartment (3xAAA alkaline battery)
Power on/off switch
Power LED
Digital buttons only
Vibration on/off switch
Using the device Plug USB receiver into USB port of PC computer, then switch ON pad. Both LED will blink, when pad automatically connects to USB receiver - power LED will be constantly on. You can switch device into analog mode, press Analog button – Analog LED will be constantly on. You can use Vibration switch to manually turn on/off vibration function. You can use game controllers/windows control panel to check the device.
Due to continuous development specification and appearance of product are subject to change without prior notice. For technical support please visit www.media-tech.eu.
