Transcript
Fiber QuickNet Cassette Rear Cable Manager Part Number: FQCRCM, FQCRCM2 INSTALLATION INSTRUCTIONS
© Panduit Corp. 2010
FS008A
FQCRCM / FQCRCM2
(3) - FMS1 Slack spools (3) - FMS2 Slack spools [FQCRCM2] [FQCRCM] [OR]
(3) - #10-32 x 3/8" Pan head screws
(1) - Strain Relief Bar (3) - Spool clamp brackets
(4) - #12-24 x .5" mounting screws
Attaching the Strain Relief Bar and Spools Note: Be sure to order and install CNRT rails when using with Panduit cabinets.
#10-32 x 3/8" pan head screw Mounting Screws Use (2) of either: #12-24 x .5", or M6 x 15mm
Slack spool
Strain relief bar Spool clamp bracket
Mounting screws
Mount the strain relief bar at the appropriate RU space. Use the lowest screw hole in the RU space.
Strain relief bar
Attach spools, if needed, as shown.
For Technical Support: www.panduit.com/resources/install_maintain.asp Page 1 of 3
(4) - M6 x 15mm mounting screws
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2010
FS008A
Recommended Cable Routing and Spool Orientation QuickNet SFQ Cassette Installation using a Standard QuickNet Patch Panel
Tak-Tys (not included) When used with QuickNet SFQ Cassettes, as shown above, the FQCRCM (shown) can support up to twenty-four MTP* interconnect cables. The FCQRCM2 can support up to thirty-six**. Only one RU is shown for clarity. Position spools as shown. Route interconnect cable from the vertical cable manager to the SFQ cassettes as shown. Use Tak-Tys to attach the fiber to the rear manager bars at the positions indicated in the illustration. Additional ribbon cable slack may be managed in the vertical manager or by making additional wraps around the slack spools. INSTALLER TIP: For best results, keep the cable transition in the vertical cable manager.
QuickNet SFQ Cassette Installation using a QuickNet Angled Patch Panel
Tak-Ty (not included) When supporting SFQ cassettes in a QuickNet Angled Patch Panel, interweave the MTP* interconnect cable for cassettes positioned in the center, as shown. * MTP is a registered trademark of US Conec Ltd.
** Spool capacity given for approximately 1 meter breakout length.
For Technical Support: www.panduit.com/resources/install_maintain.asp Page 2 of 3
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2010
FS008A
QuickNet HDQ Series Fiber Optic Cassette Installation
When used with HDQ series cassettes, as shown above, the FQCRCM (shown) can support up to twenty-four MTP* interconnect cables. The FQCRCM2 can support up to thirty-six**. Only one RU is shown for clarity. Recommended spool positions are shown.
For use with Copper Cables
Tak-Tys (not included)
When routing fiber and copper cables in the same RU space, route the fiber separately from the copper cables to avoid damage to the fiber cables. Only two MTP* interconnect cables (two cassettes) can be supported by the FQCRCM when used with 36 copper cables (6 cassettes). * MTP is a registered trademark of US Conec Ltd.
** Spool capacity given for approximately 1 meter breakout length. E-mail:
[email protected]
For Instructions in Local Languages and Technical Support: www.panduit.com/resources/install_maintain.asp
www.panduit.com Page 3 of 3
Fax: (708) 444-6993
