Preview only show first 10 pages with watermark. For full document please download

Instruction / Installation Sheet Ball Camera Microphone

   EMBED

Share

Transcript

INSTRUCTION / INSTALLATION SHEET Ball Camera Microphone 301 Fulling Mill Road, Suite G Middletown, PA 17057 Phone (800) 321-2343 / Fax (717) 702-2546 www.onqlegrand.com IS-0430 Rev. O 1. INTRODUCTION header The On-Q/Legrand Ball Camera Microphone (P/N CM1026), see Figure 1, is an optional accessory for the On-Q “Ball” style Auto Day/Night color camera. It is attached to the rear of the camera assembly, and is used to provide audio from the viewing location. The audio signal travels over the same category 5 cable connected to the camera module in the enclosure as the video signal and any required power. Figure 1 screw hole screw hole 2. DESCRIPTION The Ball Camera Microphone attaches to the rear of the camera assembly with an eight pin header (see Figures 1 & 3) and two provided screws. When properly installed, the microphone lines up with appropriate holes in the gasket, cover plate, cover mounting plate and camera assembly for proper sound detection (see Figures 4 & 5). microphone 3. INSTALLATION A. ELECTRICAL CONNECTION AND PHYSICAL ATTACHMENT 1. The Camera assembly contains a set of eight header pins (see Figure 2) for connection to the microphone PC board. Simply line up the pins with the header on the microphone PC board and gently press it onto the pins. 2. The microphone PC board is retained with two supplied screws (see Figure 3). Figure 2 RJ45 jack microphone PC board retention screw Figure 3 header Camera assembly header pins microphone sound hole Properly Installed microphone PC board Figure 5 Figure 4 ©Copyright 2008 by On-Q/Legrand All Rights Reserved. Page 1 of 1