Preview only show first 10 pages with watermark. For full document please download

Instruction Manual Bellman Alarm Clock 1172

   EMBED

Share

Transcript

Instruction manual Bellman Alarm clock 1172 Please note; the numbers within parenthesis refers to the illustrations below. Connecting the Alarm clock and bed-shaker: The enclosed wall adapter powers the Bellman Alarm clock. Connect the wall adapter into the mains and plug the wall adapter DC plug into the alarm clock (5). First time connected, it can take 1 to 2 minutes before the alarm clock starts working. During power failure, the built-in batteries power the alarm clock for about a week. Connect the bed-shaker (“vibrating device”) to the Alarm clock (4). Adjusting the time Pull out the handle (1) on the rear side to set the time. After setting the time, press the handle back in. Adjust the wake-up time Use the handle (1) to set the wake-up time. With the handle in outer position, you can set the actual time. With the handle in the inner position, you can set the wake-up time. 1 2 1 1112 1 2 10 3 9 87 6 54 6 IM1172-UK-011026 4 5 Instruction manual Bellman Alarm clock 1172 1112 1 2 10 3 9 87 6 54 Alarm on/off Push the control (2) to the upper position (“on”) to activate the wake-up alarm. Push the control (2) to the lower position (“off ”) to inactivate the wake-up alarm. Push the knob (3) down to temporarily turn the wake-up alarm off (“snooze function”). A new wake-up alarm is repeated in 5 minutes intervals. To turn off the Alarm clock permanently, use the no. (2) control as explained above. External trigger jacket The alarm clock is provided with an external trigger jacket (6). Use this jacket to activate the alarm clock by an external device (for example Bellman Visit Portable receiver, model 1033). 1112 1 2 10 3 9 87 6 54 IM1172-UK-011026 Bellman & Symfon AB Södra Långebergsgatan 30 Box 9104 SE-400 93 GOTHENBURG SWEDEN Tel. +46 31 68 28 20 Fax. +46 31 68 28 90 [email protected] www.bellman.com