Transcript
Instruction Manual Halogen Heater Model: R-024 220-240V ~ 50Hz, 1600 Watts
IMPORTANT SAFETY INSTRUCTIONS READ CAREFULLY AND KEEP FOR FUTURE REFERENCE Carefully read this manual before using this appliance. Ensure that you know how the appliance functions and how to operate it. Maintain the appliance in accordance with the instructions to ensure that it functions properly. Keep this manual with the appliance. If the appliance is to be used by a third party, this instruction manual must be supplied with it. The safety instructions do not by themselves eliminate any danger completely and proper accident prevention measures must always be used. No liability can be accepted for any damage caused by non-compliance with these instructions or any other improper use or mishandling. Do not use this appliance if it has been dropped or damaged in any way, or if the supply cord is damaged.
Confirm all parts before disposing of carton. Safely dispose of all plastic bags and other packaging components. They may be potentially dangerous to children.
GENERAL AND ELECTRICAL SAFETY When using electric appliances always observe safety regulations where applicable to reduce the risk of fire, electric shock and personal injury. Always check that the power supply corresponds to the voltage on the rating plate. Supply Cord and Plug Always unplug from mains supply when not in use. Do not abuse or damage the power cord. Check the cord regularly. Do not use the appliance if the cord or the plug has been damaged. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. Use and Location This heater is designed for indoor domestic use only. Do not use outdoors. Do not use directly below a socket outlet. This heater must be operated the right way up. Ensure the heater is located away from doorways and on a level floor where it can not be knocked over. Do not leave unattended when in use. Warning: In order to avoid overheating, do not cover the heater. Fire Risk WARNING: Fire risk exists if the heater is covered by or positioned close to curtains or other combustible materials. Do not use this heater with a programmer, timer, separate remote-control system or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly. Earth Safety This appliance must be earthed. Only connect to a suitably earthed 220-240V ~ 50Hz supply socket. Water This heater must not be used in the immediate surroundings of any bath, shower or swimming pool or used in any other damp area where contact with water may create an electrical hazard. Do not immerse any part of the appliance or supply cord in water. Do not use with wet hands. Supervision This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Safety Device This appliance has two protection devices; an internal tilt switch which disconnects the appliance when tilted or tipped over and a non resettable thermal fuse that disconnects the appliance in case of overheating.
ASSEMBLY INSTRUCTIONS Assemble the main body and the base plate together as follows. 1. Remove the butterfly nuts from the lower part of the body. 2. Insert the power cord through the hole in the middle of the base plate and then position the base plate onto the main body. 3. Secure the base plate to the main body by means of the two butterfly nuts previously removed. 4. Insert the power cord through the outlet slot and then clip it in to the cable clamp. DIAGRAM 1 2 3 4 5
Main Body Base Plate Butterfly Nut (2 pcs) Tip-Over Safety Switch Power Cord
OPERATING INSTRUCTIONS 1. 2. 3.
4. 5.
Choose a suitable location for the heater, taking into account the safety instructions above and connect the supply plug to a suitably earthed 220-240V ~ 50Hz supply socket. Press the power button to ON to turn the unit on. The heater is fitted with three additional power switches that turn the other halogen heat lamps on or off. With just the power button on, only one lamp will be on and the heating power will be 400 watts. With two lamps on the total heating power will be 800 watts, with three on, the total heating power will be 1200 watts and with all four on, the total heating power will be 1600 watts. If required select the oscillating function by pressing the turn switch on. Remember to switch the heater “OFF” at the end of use and disconnect from the mains supply.
First Time Use For first time use or when the heater is turned on after having not been used for a long period of time there may be a small amount of smoke or smell which is normal. This will disappear when the heater has been on for a short while.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC.
MAINTENANCE Regular maintenance of your appliance will keep it safe and in proper operational order. Keep the appliance clean from dust and dirt. Before Cleaning When not in use or before cleaning, always disconnect the heater from the mains supply. Cleaning Regularly clean the outside of the appliance with a soft damp cloth and dry it with a dry towel. Do not immerse in water. Do not use harsh solvents to clean the plastic. Store in a Safe Place When not in use store your appliance and all its accessories and instruction manual in a safe and dry place. Damaged or Dropped Always inspect your appliance before use. Check parts are correctly attached. Do not use this appliance if it has been damaged, dropped, left outdoors or dropped in water. Do not attempt to service this heater. There are no user serviceable parts. If it is faulty in any way return it to the place of purchase. Safety Check This heater should be checked annually by a suitably qualified person to ensure its safety and suitability for use.
At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service. Disposing of a household appliance separately avoids possible negative consequences for the environment and health, deriving form inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings in energy and resources. As a reminder of the need to dispose of household appliances separately, the product is marked with a crossed-out wheeled dustbin.
