Transcript
INSTRUCTION MANUAL
ODYS - LOOP PORTABLE STEREO MUSICSTATION FOR iPod/iPhone With FM RADIO
Disclaimer All the information, design and specifications contained in this manual were correct at the time of publication. However, as the product is under development and upgrading, the final device may have a slightly difference in appearance or modified functionality than presented in this manual.
Package Content 1. ODYS Loop 2. Remote Control (incl battery) 3. Adapter for iPod/iPhone 4. Manual 5. Warranty Card
Safety Instructions Although this product is safe, please observe the following information and warnings. • Do not expose the device to direct sunlight, extreme heat or cold, damp or dusty conditions. Malfunctions and damage and can occur as a result.. • Do not use the device in an extremely dry environment to avoid static electricity. • Do not shake the device or subject it to hard knocks. The device may be damaged if it falls. Do not place any heavy objects on top of the device. • Clean the device only using a soft, dry cloth and do not use any volatile substances, such as solvents, to avoid damaging the surface. • Do not open the casing of the device under any circumstances, and do not attempt to repair or modify the device. Disposal Do not dispose of a defective device in normal household waste disposal containers Take the defective device to your retailer or to an appropriate waste collection site. This will ensure that the device is disposed of in an environmentally-friendly way.
Support URL: http://www.odys.de See our website for the latest information on this device, on other products by our company and on our company itself. Any firmware updates for this device are also made available on our website. If you have questions or problems, please read the FAQs on our website or contact our customer support service
[email protected]. Please read following instructions prior to operating your unit. Manufacturer of this unit follows a principle of continuous improvement and has no responsibility for any changes that are made to the unit nor any liability for these changes. Thanks for your choice of our products. 0
1
1
6
2
3
4
7 8 9 10 11 12 13 15 14 20
16 17
1 2 3 4 5 6 7 8 9
18
MAIN UNIT 1. HANDLE 2. SLEEP BUTTON 3. LCD DISPLAY 4. STOP BUTTON 5. FM TELESCOPIC ANTENNA 6. SPEAKERS 7. POWER BUTTON 8. SOURCE BUTTON 9. VOLUME - BUTTON 10. VOLUME + BUTTON 11. iPod/iPhone DOCKING PUSH OPEN AREA 12. TUNING - BUTTON 13. TUNING + BUTTON 14. PLAY/PAUSE BUTTON 15. MEM BUTTON 16. VIDEO OUTPUT JACK 17. LINE IN JACK 18. BATTERY COMPARTMENT 19. AC CORD 20. REMOTE SENSOR
5
6
REMOTE CONTROL 1. POWER BUTTON 2. SLEEP BUTTON 3. iPod MENU BUTTON 4. MENU UP BUTTON 5. PREVIOUS & FAST BACKWARD BUTTON 6. ENTER BUTTON 7. MEM BUTTON 8. MENU DOWN BUTTON 9. TREBLE +/- BUTTON 10. BASS +/- BUTTON 11. MUTE BUTTON 12. SOURCE BUTTON 13. NEXT & FAST FORWARD BUTTON 14. PLAY/PAUSE BUTTON 15. VOLUME +/- BUTTON
19
11 12 13 14 15
10
2
POWER SUPPLY Plug AC plug into the outlet socket on the unit for connecting the main power.
SLEEP TIMER SETTING Following the below instructions to set the sleep timer: During playback, press SLEEP button repeatedly to cycle through the sleep time options: 90 ⎝ 80 ⎝ 70 ⎝ 60 ⎝ 50 ⎝ 40 ⎝ 30 ⎝ 20 ⎝ 10 ⎝ 00 After the sleep time setting, you can play the unit freely. Once the sleep time is expired, the unit will be switched off. During playback, press SLEEP button to check the remaining sleep time.
iPod/iPhone OPERATING PLAYING AN iPod/iPhone 1. Press iPod/iPhone DOCKING PUSH OPEN AREA to pop out the docking. Dock the iPod/iPhone on to the unit. Power on the unit, then press SOURCE button repeatedly to switch to iPod mode, and then the playback will start automatically. 2. Press PLAY/PAUSE button to start or pause the playback. 3. Press STOP button to stop the playback. 4. During playback, press TUNING + button on the unit or NEXT/FAST FORWARD button on the remote to skip to the next track; press and hold TUNING + button on the unit or NEXT/FAST FORWARD button on the remote to search through the track forward. 5. During playback, press TUNING - button on the unit or PREVIOUS/FAST BACKWARD button on the remote to skip to the previous track; press and hold TUNING - button on the unit or PREVIOUS/FAST BACKWARD button on the remote to search through the track backward. 6. Press iPod MENU button on the remote to return back to the iPod menu, press MENU UP/DOWN buttons to select your desired track for playback, press ENTER button to confirm. FM RADIO TUNING THE FM RADIO 1. Power on the unit, switch to RADIO mode by pressing SOURCE repeatedly. 2. Press TUNING +/- button on the unit or NEXT/PREVIOUS button on the remote to fine tune radio station. Press and hold TUNING +/- button on the unit or NEXT/PREVIOUS button on the remote to auto search radio station forward or backward respectively. When an available station will be found, the unit will broadcast it immediately and the searching will be stopped.
3
STORING YOUR FAVORITE RADIO STATION 1. During playback, press and hold MEM button on the unit or short press MEM button on the remote for storing the current station, a memory cell number flashes on the screen. 2. Use TUNING +/- button on the unit or MENU UP/DOWN button on the remote to select the corresponding memory cell among P01-P20 for storing the station. 3. Confirm your selection by pressing MEM button on the unit or on the remote. 4. During radio playback, press MEM button on the unit, and then press TUNING+/- button on the unit to recall the stored stations. You also can press MENU UP/DOWN button on the remote repeatedly to select your desired stored stations for broadcasting. MUTE THE UNIT During playback, press MUTE button to switch off the audio. Press the button again to resume the audio. VOLUME LEVEL/TREBLE/BASS ADJUSTMENT Press VOLUME +/- button or TREBLE +/- button or BASS +/- button to adjust the volume output level or treble effect or bass effect.
LINE IN Follow steps to connect the unit to another audio device: 1. Connect the device into the player’s LINE IN jack with the LINE OUT cables. 2. Press POWER button to turn the unit on. 3. Press SOURCE button repeatedly to switch the unit to LINE IN mode. 4. Power on the device and begin play.
VIDEO OUTPUT 1. Dock a iPod/iPhone to the unit. 2. Connect RCA cable to the VIDEO OUTPUT jack on the unit and the TV set. 3. Power on the unit and the connected TV set. Press SOURCE button repeatedly to switch to iPod mode. 4. Change the TV set to the proper input mode. 5. Video from a docked iPhone/iPod can now be played through the bar speaker to the connected television. Note: Make sure the docked iPhone or iPod’s TV out option is turned on.
TROUBLE SHOOTING CONNECTING WITH OTHER APPLIANCES
Symptom Radio sound distorted.
Possible Cause 1. The station is not tuned in. 2. The signal is poor.
No radio sound.
1. The unit is not in tuner mode. 2. The volume has been muted or is on the minimum setting.
The iPod will not play
1. The unit is not in iPod mode. 2. The iPod is not connected correctly. 1. The unit is not in iPod mode. 2. The volume has been muted or is on the minimum setting.
No iPod sound.
4
5
Solution 1. Fine tune the station. 2. Extend the FM telescopic antenna, change the direction of the antenna. 1. Press SOURCE button repeatedly until switching to tuner. 2. Adjust the volume level or press MUTE button to resume audio. 1. Press SOURCE button repeatedly until switching to iPod. 2. Reconnect the iPod. 1. Press SOURCE button repeatedly until switching to iPod. 2. Adjust the volume level or press MUTE button to resume audio.
IMPORTANT SAFETY INSTRUCTIONS y The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. y When the mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. To be completely disconnected the power input, the mains plug of the apparatus or the appliance coupler shall be disconnected from the mains completely. y No naked flame sources, such as lighted candles, should be placed on the apparatus. y Minimum distances 2.0cm around the apparatus for sufficient ventilation. The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc. y The use of apparatus is in tropical and/or moderate climates. y Attention should be drawn to the environmental aspects of battery disposal. y CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. y Battery shall not be exposed to excessive heat such as sunshine, fire or the like. y The marking plate is located at the bottom of the apparatus.
Play&Charge
Video Output
Bracket
iPhone
●
●
12
iPhone 3
●
●
12
iPhone 3GS
●
●
12
iPhone 4
●
●
iPod Touch 1st generation
●
●
14
iPod Touch 2nd generation
●
●
14
iPod Touch 3rd generation
●
●
14
iPod Touch 4th generation
●
●
iPhone
iPod Touch
iPod nano iPod nano 1st generation
●
8
iPod nano 2nd generation (aluminium)
●
8
iPod nano 3rd generation (video)
●
●
13
iPod nano 4th generation (video)
●
●
8
iPod nano 5th generation (video camera)
●
●
8
iPod nano 6th generation
●
●
iPod Classic 80GB
●
●
10
iPod Classic (2007) 160GB
●
●
10
iPod Classic (2009) 120/160GB
●
●
10
iPod 4th generation 20/40 GB
●
iPod 4th generation (colour display) 20/30 GB
●
●
iPod 4th generation (colour display) 40/60 GB
●
●
iPod 5th generation (video) 30/60/80GB
●
●
iPod mini
●
iPod and iPod mini
6
7
10 10
10
Warranty Conditions The following conditions comprise the requirements and scope of our warranty conditions and do not affect our legal and contractual warranty obligations. We offer a warranty on our products in accordance with the following conditions: 1. AXDIA products are covered by a 24 month warranty. We will resolve damages or defects on AXDIA products free of charge within 12 months of the purchase date under the following warranty conditions. For any damage or defect determined later than 12 months after the purchase date, proof of a manufacturing fault must be submitted for repair under warranty. The warranty does not cover batteries and other parts, which are considered consumables, parts that break easily such as glass or plastic or defects based on normal wear and tear. There is no warranty obligation in the event of marginal differences compared to the target appearance and workmanship provided these have a negligible effect on the product's fitness for use, in the event of damage caused by chemical or electrochemical effects, by water or generally from abnormal conditions. 2. The warranty will be performed in such a way that we shall decide whether to repair the defective parts or to replace them with working parts free of charge. AXDIA reserves the right to exchange the product for a replacement product of equal value if the product that is sent in cannot be repaired within a reasonable time or at reasonable cost. The product can also be exchanged for a different model of the same value. Requests cannot be made for repairs to be carried out on site. Parts that have been replaced or exchanged become our property. 3. The warranty claim does not apply if repairs or other work is carried out by unauthorized persons or if our products are equipped with additional parts or accessories that are not approved for our products. 4. Warranties that have been activated do not cause the warranty period to be extended, nor do they trigger a new warranty period. The warranty period for any replacement parts installed ends with the warranty period for the entire product. 5. Any other or further claims are excluded, especially those for replacement due to damage caused outside of the product, provided there is no obligatory legal liability. We therefore accept no liability for accidental, indirect or other consequential damage of any kind, which leads to usage restrictions, data loss, loss of earnings or interruption to business.
IMPORTANT: AXDIA will only accept parcels that have an RMA number. Please observe the following when sending the product: 1. Send the product suitably packaged with carriage and insurance paid. Do not enclose any accessories with the products (no cables, CD's, memory cards, manuals, etc.), unless the AXDIA Service Centre specifies otherwise. 2. Mark the RMA number on the outside of the package in such a way that it is visible and clearly legible. 3. You must enclose a copy of the sales slip as proof of purchase. 4. Once AXDIA has received the product, it will meet its warranty obligations in accordance with the warranty conditions and will return the product to the sender with carriage and insurance paid. Service outside of warranty AXDIA can refuse any service claim made that is not covered by the warranty. If AXDIA agrees to provide a service outside the warranty, the customer will be invoiced for all repair and transport costs. AXDIA will not accept any packages that have not first been approved by AXDIA by means of an RMA (Return Material Authorization).
Asserting a warranty claim 1. To make use of the warranty service, you must contact the AXDIA Service Center by e-mail, fax or phone (see below for contact details). You can also use the service form on our website or on the back of the warranty conditions. 2. AXDIA Service Center will try to diagnose and solve your problem. If it is determined that a warranty claim exists, you will be given an RMA number (Return Material Authorization) and you will be asked to send the product to AXDIA.
8
9
